Product Manual
WOLO LUXOR MODELS - PAGE 3
11. The hooked end of the stainless steel strap that is engaged to the vehicle’s window ledge has two
holes, which will secure the bracket to the vehicle with sheet metal screws. Use each of the holes in the
bracket as a template mark and drill the required holes into the window ledge, drill to size 5/32”. Secure
the stainless steel strap to the window ledge with the self-tapping sheet metal screws. IMPORTANT:
The installer may have to lower headliner and inspect the selected location to ensure that there are no
components, wires and or any other vehicle part that could be damaged by drilling. See Fig. 4.
12. Place the weather-stripping back into position.
13. Insert the cables
and the red and black wires into the access hole
that was drilled into the roof earlier and make sure the rubber
grommet has been installed into the drilled hole. Route the cables
into the B-pillar.
14. The power cable will make an approximate 90° bend into the B-pillar.
Depending on the vehicle, this can sometimes be difcult, but it is
the recommended procedure for proper installation. Installation will
vary for each make and model vehicle and it is up to the installation
technician’s discretion whether to route the power cable as
recommend through the B-pillar or use an alternative routing method.
Route cables down to the bottom of the B-pillar and the pull the full
length of both cables into the interior of the vehicle. See g. 5.
15. The rubber grommet that is attached to the power cable, is inserted into the access hole. See g 2.
16. Make sure that the light’s cable has been completely pulled into the vehicle, use silicon or similar
waterproof material around the grommet and cables to ensure a waterproof installation.
MOUNTING SWITCH CONTROL PANEL
The light bar’s switch control panel needs to be mounted in a location that can easily be reached.
IMPORTANT: Do not connect the power plug to the switch controller until all mounting and wiring has been
completed and a safety check has been completed. WARNING: If the vehicle is equipped with air bags, the
installer MUST consult the vehicle’s shop or build manual to ensure that light’s switch controller and wires that
will be connected to the switch controller, will not affect deployment of air bags. This switch controller must be
installed only in a location recommended by vehicle manufacturer. If necessary, consult manufacturer for their
recommendation. Failure to adhere to this warning could result in damage to the air bag and or reduce the
effectiveness of the air bag, which could result in bodily injury, or death to you or others.
CAUTION
• Before drilling any surface for mounting siren of the switch controller or for routing wires carefully inspect
the desired location to ensure that there are no components, wires and or any other vehicle part that could be
damaged by drilling.
• The switch controller should not be mounted close to the vehicle’s
heater duct.
17. Remove the controller from the mounting bracket using the
thumb screws on each side. Use the bracket as a template to
mark the location of the mounting holes.
18. Drill four-(4) holes on the marked locations using a 5/32” drill bit.
19. Secure the swing-mounting bracket to the desired location using
the sheet metal screws provided. See g 6.
20. Reposition the switch controller back into the swing bracket, you can tilt and position the controller so that
it is easily reachable by user. Tighten the two thumb screws that secure the switch controller to the swing
bracket. See g 6.
Fig. 5
Fig. 6
Mounting Bracket
Thumb
Screws