Product Manual

29. To prevent shorts, make sure all wire connections are properly insulated.
30. Make sure all wires are securely fastened to the vehicle using plastic wire ties or electrical tape (not
provided). WARNING: Carefully inspect the interior driver’s area to make sure the light bar wires or the
vehicle’s electrical system wires are not interfering with the operation of vehicle’s controls; accelerator,
brake, clutch pedals and etc.
OPERATING LIGHT BAR
31.
The top row left button on the switch controller is the light bar’s power on/off. When the light bar’s
power is turned on, all of the push buttons on the face of the switch controller will illuminate. The light bar
will flash in the same light pattern that was last used before shut down.
31A. LOW POWER: The top row center button controls two levels of brightness for the warning lights, either full
or 30%. Press the LOW POWER button once to change brightness.
31B. F1: The top row right button allows the user to memorize one favorite light pattern. To program: select
the light pattern to be your favorite (Note the pattern numerical display for pattern number), press and
hold the F1 button for three (3) seconds, programming is complete. Stored light pattern can be recalled
instantly by pressing F1 momentarily. Repeat the above procedure any time the user wants to change
the light pattern controlled by the F1 button.
31C. ◄ The middle row left button controls the light pattern. Press to change to the next declining pattern in
the 20 pattern series. (Ex. Switch from pattern 10 to pattern 9). The controllers flash pattern indicators will
display the pattern in use for a period of five seconds. The numerical display will remain illuminated to the
selected pattern number.
31D. DEFAULT: The middle row center button when pressed will default to pattern 01. The controllers flash
pattern indicators will display the 01 pattern for a period of five seconds. The numerical display will
illuminate 01.
31E. ► The middle row right button controls the light pattern. Press to change to the next increasing pattern
in the 20 pattern series. (Ex. Switch from pattern 9 to pattern 10). The controllers flash pattern indicators
will display the pattern in use for a period of five seconds. The numerical display will remain illuminated to
the selected pattern number.
31F. ALLEY LEFT: The bottom row left button controls the left alley light. When the button is pressed the driver
side alley light will illuminate. The controller’s left alley light indicator will illuminate for a period of five
seconds. Press button again to turn off the light.
31G. TAKE DOWN: The bottom row center button controls the take down lights. When the button is pressed the
front two alley lights will illuminate. The controller’s front alley light indicator will illuminate for a period of
five seconds. Press button again to turn off lights.
31H. ALLEY RIGHT: The bottom row right button controls the right alley light. When the button is pressed
the passenger side alley light will illuminate. The controller’s right alley light indicator will illuminate for a
period of five seconds. Press button again to turn off the light.
CLEANING
A scratched, dull or dirty lens will cause a reduction in brightness of warning light. Never use a caustic or
petroleum based cleaner on any surface of the warning light. For best cleaning results, always use household
glass cleaner or mild soap with a soft lint free rag. If the lens has scratches, or is dull, it is recommended those
components be replaced to ensure maximum brightness of the warning light.