Product Manual

ELECTRICAL CONNECTIONS FOR A NEW HORN BUTTON SWITCH:
Install the relay in a dry location with the terminals facing downward near the compressor. Refer to figure 4 for wiring.
A. Connect relay terminal 87 to the positive terminal at the bottom of the compressor. Use no less than a 16-gauge
wire.
B. Connect relay terminal 85 to
the horn switch terminal. The
other horn switch terminal is
connected to ground (body of
vehicle). An 18-gauge wire is
suggested for this connection.
C. Connect relay terminals 30/86
to positive (+) 12-volt battery,
alternator or accessories. Use
16-gauge or heavier wire. A
20-ampere fuse is suggested
to be installed as shown in
Figure D.
TOGGLE SWITCH
INSTALLATION
The toggle switch, included in kit,
will control the horn’s sounds. One
position for a steady three trumpet sound and the other will
produce a turkey sound.
1. Mount the toggle switch in an accessible location inside the
Vehicle.
2. Connect one terminal of the toggle switch to ground, any
body bolt in the dashboard area. Make sure the surface is
clean from dirt and rust so as to make a good
electrical connection.
3. Connect the other terminal of the toggle switch to the
compressor’s minus (-) terminal on the side of the compressor
using the black wire with the insulated terminal provided.
4. Attach the red wire with the insulated terminal to the compressor’s
positive (+) terminal on the side of the compressor. Splice the other end of the wire to the wire that is connected
on the bottom of the compressor’s motor marked positive (+), as shown in Fig. E.
Warranty
Wolo Manufacturing Corporation (“Wolo”) warranties to the original purchaser, for three months from the date of purchase,
that this product is free from defects in workmanship and materials. If there is such a proven defect, Wolo, at its option, will
either repair or replace the item free of charge, if it is returned to Wolo within three months from the date of purchase
together with proof of purchase as described below. Wolo reserves the right to inspect any defect prior to settling any
warranty claim by repair or replacement. This warranty is limited as above provided and Wolo will not be responsible for fire
or other casualty or accident, due to neglect, abuse, abnormal use, modifications, faulty installation of this product, or
natural causes.
ANY EXPRESSED WARRANTY NOT PROVIDED HEREIN IS EXCLUDED AND DISCLAIMED. THE IMPLIED WARRANTIES OF
MERCHANTABILITYAND OF FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY LIMITED TO ATERM OF THREE (3)
MONTHS. UNDER NO CIRCUMSTANCES SHALL WOLO BE LIABLE TO PURCHASER OR ANY OTHER PERSON FOR ANY
SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHER ARISING OUT OF BREACH OF WARRANTY OR OTHERWISE.
To obtain warranty service, return the product prepaid, and include the original bill of sale showing the date of purchase. Provide
with the return a brief description of the problem. Also, include with the return a check or money order in the amount of $10.00 to
cover return shipping. Mail to:
Wolo Manufacturing Corp. One Saxwood Street, Deer Park, NY
11729 Attn: Warranty Service E-mail: [e-mail]
© 2006 W olo Mfg. Co r p All Rights
Reserved.
RECAP OF TERMINAL CONNECTIONS
Terminals 30/86: the two (2) terminals are connected to 12-volt positive (+) using a fuse.
Terminal 85: connect horn switch negative (-).
Terminal 87: connect positive (+) terminal of compressor.