Product Manual

INSTALLATION INSTRUCTIONS

For Model 410 Wobbler horn

The addition of a Wolo horn kit in your vehicle will provide an extra level of sound. The Wolo name, with more than

twenty years experience, is your guarantee of a superior horn product. If you need help installing your new Wolo horn,

our technicians are available to answer your questions, Monday thru Friday, from 9 AM to 4 PM EST at 1-888-550-

HORN (4676).

1. Install the compressor in the engine compartment in a dry

location and safe from engine and exhaust manifold heat.

To secure the compressor, drill a 3/16-inch hole. Mount

compressor vertically (air outlets at the top). Install the

head of the bolt into the slot on the compressor’s housing

and secure to the vehicle using the lock washer/nut

provided. (See Fig. A).

2. Position each trumpet with open end facing down, mark

and drill a 1/4-inch hole for each trumpet. Secure to vehicle

referring to Figure B. Use mounting hardware in order

shown - spacer, lock washer/nut.

3. IMPORTANT: Mount trumpets with the

open ends facing down. This will prevent

water from entering into the trumpets and

compressor. Water damage to the horn’s

component parts is not covered by our

factory warranty.

4. Using plastic air tubing included in the kit, cut to proper length and install

referring to Figure C. The inlet fitting on each trumpet has a colored ring.

When connecting the plastic tubing , mate with the same color ring on the

compressor outlet fitting. CAUTION: Avoid making any kinks or sharp

bends in tubing that will restrict the airflow and alter the horn's sound.

ELECTRICAL CONNECTIONS USING VEHICLE’S

FACTORY HORN SWITCH

For a vehicle with a (2) wire system: If vehicle’s factory horn has two (2) terminals, simply transfer the wires to the

terminals on the bottom of the compressor. IMPORTANT: when testing the horns, if compressor motor turns on but

the horn does not sound, reverse the wires connected at the bottom of the compressor.

For a vehicle with a (1) wire system: If vehicle’s factory horn has two (1) terminal, simply transfer wire to the

compressor’s positive (+) terminal on bottom of compressor. The compressor’s negative terminal is connected to any

metal body ground. Connection should be free of rust or paint.

PAGE 1
INSTALLATION INSTRUCTIONS For Model 410 Wobbler horn The addition of a Wolo horn kit in your vehicle will provide an extra level of sound. The Wolo name, with more than twenty years experience, is your guarantee of a superior horn product. If you need help installing your new Wolo horn, our technicians are available to answer your questions, Monday thru Friday, from 9 AM to 4 PM EST at 1-888-550HORN (4676). 1.
PAGE 2
ELECTRICAL CONNECTIONS FOR A NEW HORN BUTTON SWITCH: Install the relay in a dry location with the terminals facing downward near the compressor. Refer to figure 4 for wiring. A. Connect relay terminal 87 to the positive terminal at the bottom of the compressor. Use no less than a 16-gauge wire. B. Connect relay terminal 85 to the horn switch terminal. The other horn switch terminal is connected to ground (body of vehicle). An 18-gauge wire is suggested for this connection. C.