Product Manual

Your choice of a Wolo’s warning light is the perfect choice to compliment your vehicle. Our warning lights are
manufactured with the finest of material. Each light is tested before it is packaged. Our quality workmanship and
components is Wolo’s assurance of a product that will give years of dependable service.
MOUNTING (Fig. A)
1. Select the location you wish to mount the warning light on. For best results
you should make sure the lens is unobstructed so that the light can be seen
360 degrees.
2. Using the holes in the warning light’s base, mark the two (2) hole locations for
mounting the light. Lift the light from the mounting location and drill holes using
a 3/16 inch bit.
3. If needed, drill a hole for the wires using a 5/16 inch bit and insert the plastic
grommet into the hole. The plastic grommet will ensure that there are no sharp
edges around hole that could damage the wires.
4. IMPORTANT: Use some silicone caulking around wires and plastic grommet if
waterproofing is required.
5. Secure the base of the warning light to the vehicle using only the hardware provided by Wolo. To prevent vibration
and water leaks use the rubber gasket provided.
WIRING (Fig. B)
6. Connect the warning light’s RED wire to a power source
(+) 12-100 volts such as battery, alternator, etc. use a 2-
amp inline fuse (not provided).
7. Connect the warning light’s BLACK wire to your on/off
switch (not provided).
8. Connect the other terminal or wire from the on/off switch
to ground, by placing the wire under any metal body bolt
that is clean of paint and rust.
9. If you should need to lengthen any wires use 18 gauge or
heavier. Make sure connections are taped and secured.
Rated to operate at: 12- volts DC.
If you need help installing your new Wolo Lightning Bright, our technicians are available to answer your questions
Monday thru Friday 9 AM to 4 PM EST at 1-888-550-4676.
ANY EXPRESSED WARRANTY NOT PROVIDED HEREIN IS EXCLUDED AND DISCLAIMED. THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY LIMITED TO A TERM
OF THREE (3) MONTHS. UNDER NO CIRCUMSTANCES SHALL WOLO BE LIABLE TO PURCHASER OR ANY OTHER PERSON
FOR ANY SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHER ARISING OUT OF BREACH OF WARRANTY OR OTHERWISE.
To obtain warranty service, return the product prepaid, and include the original bill of sale showing the date of purchase. Provide with
the return a brief description of the problem. Also, include with the return a check or money order in the amount of $10.00 to cover
return shipping. Mail to:
Wolo Manufacturing Corp.
One Saxwood Street, Deer Park, NY 11729
Attn: Warranty Service
E-mail: [e-mail]
© 2011 Wolo Mfg. Corp All Rights Reserved.
WARRANTY
Wolo Manufacturing Corporation (“Wolo”) warranties to the original purchaser, for three months from the date of purchase, that
this product is free from defects in workmanship and materials. If there is such a proven defect, Wolo, at its option, will either repair
or replace the item free of charge, if it is returned to Wolo within three months from the date of purchase together with proof of
purchase as described below. Wolo reserves the right to inspect any defect prior to settling any warranty claim by repair or
replacement. This warranty is limited as above provided and Wolo will not be responsible for fire or other casualty or accident, due
to neglect, abuse, abnormal use, modifications, faulty installation of this product, or natural causes.
100
INSTALLATION INSTRUCTIONS FOR
WOLO LIGHTNING BRIGHT
®
2 MODEL 3930-A