Product Manual

Your choice of a Wolo warning light will complement your vehicle. Wolo’s products are manufactured

with the ﬁnest materials. Each light is tested to meet our high standards before it is packaged, to

assure you receive a perfect warning light. Our quality workmanship and components are Wolo’s

assurance of a product that will give years of dependable service. If you need help using your new

Wolo warning light, our technicians are available to answer your questions, Monday thru Friday, from

9 AM to 4 PM EST at 1-888-550-4676.

MAGNET MOUNTING:

IMPORTANT: Vehicle roof construction varies for most vehicles as well as driving conditions. The

vehicle should never be driven with this warning light magnetically mounted. It is possible that the

light could dislodge off the mounting surface and cause damage, injury or death. Ignoring this warning

shall be the sole responsibility of the user and or vehicle owner.

IMPORTANT: The magnets’ holding power to the mounting surface is dependent upon the following:

ﬂatness, thickness, condition and ﬁnish of the mounting surface. For maximum magnet strength,

follow these recommendations:

1. The vehicle’s mounting surface should be kept clean and free of wax, dirt, dust and foreign

particles.

2. The bottom of the magnets’ rubber cover should be kept clean and free of wax, dirt, dust and

foreign particles.

3. Always make sure that the mounting surface is ﬂat and that two (2) magnets are fully secured.

4. Never attempt to secure the magnets to a vehicle that has a fabric or vinyl covering the mounting

surface.

5. Once you have located the desired mounting location, you should make sure the lens is

unobstructed so that the light can be seen 360 degrees.

POWERING WARNING LIGHT: Fig. 1

6. To turn on the light bar, simply insert the light’s cigarette lighter plug into the vehicle’s power outlet.

Press the on/off button on the back on the cigarette lighter plug. When the light is operating the

LED on the plug’s rocker switch will illuminate

7. To turn off the warning light, remove the cigarette lighter plug from the vehicle’s power socket or

position the on/off switch to off.

INSTRUCTIONS FOR USE

MODELS 3725M-A & 3726M-A

CUBIE LED WARNING LIGHT

Fig. 1

CONTACT

NUT

5 AMP FUSE

LIGHT

PATTERN

CONTROL

SWITCH

ON / OFF

SWITCH

PAGE 1
INSTRUCTIONS FOR USE MODELS 3725M-A & 3726M-A CUBIE LED WARNING LIGHT Your choice of a Wolo warning light will complement your vehicle. Wolo’s products are manufactured with the finest materials. Each light is tested to meet our high standards before it is packaged, to assure you receive a perfect warning light. Our quality workmanship and components are Wolo’s assurance of a product that will give years of dependable service.
PAGE 2
IMPORTANT: The warning light’s cigarette lighter plug has a built-in fuse to protect the light and the vehicle. If the warning light does not turn on when the plug is inserted into the vehicle power outlet, check the fuse by the following method: The tip of the power plug has a chrome push-in contact which is secured by the plastic nut. Unscrew the nut, and you will have access to the fuse. If the fuse needs to be replaced use a 5-amp fuse.