Use and Care Manual

TECHNICAL DATA
WOL-16
DURASTAIN
®
ONE COAT SEMI-TRANSPARENT STAIN
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 800∙373∙633
www.rustoleum.com/wolman
Form: GDH-697
Rev.: 020921
PHYSICAL PROPERTIES
ONE COAT SEMI-TRANSPARENT STAIN
Resin Type
Modified Alkyd/Acrylic Blend
Pigment Type
Iron Oxides and Mica
Solvents
Water
Weight
Per Gallon
8.5-8.6 lbs.
Per Liter
1.0 kg
Solids
By Weight
22.0-22.9%
By Volume
19.4-20.2%
Volatile Organic Compounds
<100 g/l (0.83 lbs./gal.)
Recommended Dry Film Thickness
(DFT) Per Coat
1.0-1.5 mils
(25-37.5µ)
Wet Film to Achieve DFT
5.0-7.5 mils
(125-187.5µ)
Theoretical Coverage at 1 mil DFT (25µ)
311-324 sq.ft./gal.
(7.7-8.0 m
2
/l)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
Approximately 250 sq.ft./gal
(6.2 m
2
/l)
Dry Times @ 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
1 hour
Light Traffic
24 hours
Replace
Furniture
48 hours
Full Cure
7 days
Protect from Rain
24 hours
Shelf Life
3 years
Flash Point
>200°F (93°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.