Technical Specifications

TECHNICAL DATA
WOL-07
DECKSTRIP
®
ASR
ACRYLIC STAIN REMOVER
1
Form: GDH-805
Rev.: 060518
DESCRIPTION AND USES
Wolman
®
DeckStrip
®
ASR Acrylic Stain Remover is a ready-
to-use, premium quality, exterior wood stripper for all types
of acrylic deck and siding stains. In just 15 minutes,
DeckStrip ASR will cut through and remove relatively new or
weathered acrylic/latex solid and semi-solid stains, including
those labeled 100% acrylic. With the aid of a highly
concentrated formula, special wetting agents and a thickener
for vertical surfaces, tough-to-remove acrylics are quickly
dissolved and easily rinsed away with a pressure-washer –
no scraping or sanding required. Once stripped, wood is
restored to its bright, clean, natural look. Using DeckStrip
ASR before re-application of a protective finish or stain
ensures its proper adhesion, penetration and optimum
performance.
FEATURES
 Spray on, pressure wash away
 No scraping or sanding
 Clings to vertical surfaces for one application stripping
 Biodegradable
PRODUCT
SKU
DESCRIPTION
14706
1 Gallon
RECOMMENDED USES
FOR EXTERIOR USE ONLY
Use DeckStrip ASR to strip and restore outdoor wood decks,
fences, siding, shakes and shingles, boat docks &
boardwalks, outdoor furniture & décor, gazebos & arbors,
play sets and more.
WOOD TYPES: Use on all wood types, including pressure
treated lumber, Cedar, Redwood, exotic hardwoods
(Mahogany, Ipé, Teak, etc.), and North American
hardwoods.
Note: To strip traditional oil or solvent-based deck stains,
semi-transparent stains, toners, tinted wood protectors or
sealers, select Wolman DeckStrip Stain & Finish Remover
and use according to label directions.
PRODUCT APPLICATION
Before You Start: Make sure entire wood surface is dry and
free of dust, dirt and debris. If the surface is hot to the touch
or in direct sunlight, dampen with fresh water to cool. Apply
when outside temperatures are above 40°F. Pre-rinse
grass, plants and shrubs surrounding the wood structure to
be stripped, and then cover foliage to protect it from
exposure to the product. Mask off siding and cover all wood
surfaces not intended to be stripped. Cover any exposed
aluminum surfaces (siding and flashing) to prevent
corrosion. Protect adjacent concrete surfaces from rinse
water. Sweep away surface dirt and debris. Remove any
standing water before beginning application.
Weather Conditions:
For best results, apply when outside temperature is above
50°F (10°C), and when 24 hours of precipitation-free
weather is expected. Surface to be stripped should be out of
direct sunlight to avoid premature evaporation of the product.
Safe Handling directions must be followed to avoid exposure
to over-spray. (See Handling and Storage section)
CAUTION: Bare wood and/or coated surfaces can become
slippery when wet. Use caution when walking on wet
surfaces.
Prepare to Use:
Moderately shake container, then pour into sprayer tank. If
using a brush or mop, pour product into a 2-½ gallon plastic
bucket. Do not mix with any other products.
Apply:
A synthetic bristle brush or mop, pump sprayer or airless
sprayer (with no aluminum parts) is recommended. When
working on vertical surfaces start at the bottom and work to
the top of the structure.
Working on 20 square feet at a time to maintain optimum
surface wetness, apply product and let sit for 15 minutes. If
stripper dries prematurely, keep it wet with additional product
as needed.