Use and Care Manual

TECHNICAL DATA
DECKSTRIP STAIN & FINISH REMOVER
3
Rust-Oleum Corporation Form: JPB-18
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 082113
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
Active Ingredient
Sodium Hydroxide
Weight
Per gallon
8.7 - 9.2 lbs
1.04 -1.09 kg
Per liter
Ph
13 minimum
Theoretical Coverage
Depending on coating type, number of layers, surface porosity and method of application
one (1) gallon covers approximately 150 sq. ft.
Application Parameters
Minimum 40°F
Dry Time
Allow wood to dry thoroughly before applying a water based stain or finish.
Allow a minimum of 24 hours before applying oil based stain or finish.
Biodegradable
Biodegrades into inert chemicals
Flash Point
>200°F
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.