Use and Care Manual

TECHNICAL DATA
DECKSTRIP STAIN & FINISH REMOVER
Form: JPB-18
2 Rev.: 082113
HANDLING AND STORAGE .
Clean Up:
Clean tools and equipment immediately after use with soap and
water. Use water or vinegar-soaked rag to wipe off any drips or
spills on unintended surfaces immediately.
Safe Handling:
During preparation and application, wear rubber or plastic coated
gloves and safety goggles. If applying with a sprayer, wear a
NIOSH-approved full-face respirator with an organic vapor
cartridge and N-95 pre-filter. Care should be taken to cover any
exposed aluminum surfaces to prevent discoloration, as this
product is corrosive to metal.
DO NOT MIX WITH ANY OTHER PRODUCTS, especially
those containing chlorine or bleach (sodium hypochlorite). Rinse
grass and plants with water after exposure.
Precautions:
DANGER! MAY BE FATAL IF SWALLOWED. CAUSES
SEVERE BURNS. CONTAINS SODIUM HYDROXIDE. May be
harmful if swallowed. Causes eye and skin irritation. Prevent
contact with eyes and skin. During preparation and application,
wear rubber or PVC gloves and safety goggles. Wash
thoroughly after handling. May cause respiratory and throat
irritation. Do not breathe spray mist. If applying with a sprayer,
wear a properly fitted, NIOSH approved respirator. Use only with
adequate ventilation.
KEEP OUT OF REACH OF CHILDREN.