Technical Specifications

Technical Data
Weight per Gallon: 7.5 +/- 0.1 lbs.
Solids by Weight: 68 – 72%
Solids by Volume: 64 – 68%
Viscosity Range: 18-22 seconds #2 Zahn
V.O.C. Content: Max. 2.5 lbs./gal. 300 g/l
Meets federal and all states V.O.C.
requirements.
Flash Point: 104 ° F
Compatibility: This product must penetrate the
surface to work properly -- do not apply
over a sealed surface or use as a
primer coat.
Precautions
GENERAL PRECAUTIONS AND RESTRICTIONS -
Residential Users: Do not apply this product in a way
that will contact any person or pet. DO NOT USE ON
WOOD WHICH WILL COME IN CONTACT WITH
FOOD. Apply this product only as specified on the label.
Keep container closed when not in use. Wear goggles,
rubber gloves and protective clothing when applying or
handling treated lumber. Use only in a ventilated area.
Keep contents and freshly treated articles away from
food and living plants.
PRECAUTIONARY STATEMENTS –
HAZARDS TO HUMANS AND DOMESTIC ANIMALS
CAUTION: Causes moderate eye irritation. Harmful if
swallowed, absorbed through skin or inhaled. Avoid
contact with eyes or clothing. Do not breathe vapor or
spray mist. Use only in well-ventilated area, keep
containers closed. Do not take internally. Wash
thoroughly with soap and water after handling.
ENVIRONMENTAL HAZARDS: This product is toxic to fish.
Do not apply direct to water or to areas where surface water
is present or to intertidal areas below the mean high water
mark. Do not contaminate water when disposing of
equipment washwaters or rinsate.
PHYSICAL OR CHEMICAL HAZARDS:
COMBUSTIBLE: Do not use or store near heat or open
flame.
IN CASE OF FIRE: Use dry chemicals, foam, water, fog
carbon dioxide or CO
2
. Cool closed containers with water.
Limited Warranty – 3 Year Performance Guarantee
The Company warrants, for three years after date of purchase,
Wolman
®
F&P
®
Finish And Preservative (Product) will
protect wood substrate surfaces against rot and decay,
prevent warping or splitting damage caused by water
penetration, and resist peeling or blistering of the coating
film. This warranty does not apply to wood that was rotting,
decaying, splitting, or warping prior to application of the
Product, or to pressure-treated wood that cracks, splits or warps
after Product application due to escape of internal moisture.
This warranty applies to Product applied to newly installed or
pre-existing wood surfaces only if the surface has been properly
prepared and the Product has been properly applied in
accordance with directions on the Product Label. Label
directions are as complete as possible but cannot encompass
all conditions, applications and/or surfaces, all of which are
beyond manufacturer’s and seller’s control. This warranty
does not apply to use of the Product in combination with
other materials. See Product label for warranty remedy
instructions.