Technical Specifications

TECHNICAL DATA
WOLMAN
®
F&P
®
FINISH AND PRESERVATIVE
Rust-Oleum Corporation Form: GDH-18
11 Hawthorn Parkway Phone: [phone] Rev: 052418
Vernon Hills, Illinois 60061 www.rustoleum.com
,PHYSICAL PROPERTIES
PHYS
IC
FINISH & PRESERVATIVE
Resin Type
Alkyd
Pigment Type
Inorganic
Solvents
Mineral Spirits
Weight
Per Gallon
9.4 lbs.
Per Liter
1.13 kg
Solids
By Weight
48-50%
By Volume
46-48%
Volatile Organic Compounds
<280 g/l
(15.0 lbs./gal.)
Recommended Dry Film Thickness
(DFT) Per Coat
3.0-4.0 mils
(75-100µ)
Wet Film to Achieve DFT
(unthinned material)
6.0-8.0 mils
(150-200µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
1
st
Coat -150-200 sq.ft./gal. (Varies with wood type and porosity)
2
nd
Coat – 200-300 sq.ft./gal. (Varies with wood type and porosity)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Tack-free
4-8 hours
Recoat
8-12 hours
Light Traffic
24-48 hours
Full Cure
72 hours
Shelf Life
3 years
Flash Point
105°F (41°C)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.