Instructions

~ 51 ~
3. Also remove the cover of the electronic control box / cable storage (E) from the
housing of the extractor hood (B) using a screwdriver (s. fig. below). Keep the
cover (E) and the screws (F / 6 pcs. ST3*12) in a safe place; they will be needed
again during the installation.
A
WORKTOP / INSTALLATION OPENING
B
EXTRACTOR HOOD: HOUSING
C
METAL SUPPORTS / 2 pcs.
D
SCREWS OF THE METAL SUPPORTS / 4 pcs. M4*12
E
COVER OF THE ELECTRONIC CONTROL BOX / CABLE STORAGE
F
SCREWS OF THE COVER / 6 pcs. ST3*12
4. Insert the extractor hood into the installation opening carefully (s. fig. below).