Instructions

45
HOW TO CALIBRATE THE REMOTE CONTROL:
Before you can use the remote control, you must calibrate it to the extractor
hood. Proceed as follows:
1. The extractor hood must be in STAND - BY MODE (display indicates « 0 » /
illuminant is switched off).
2. Press and hold the button on the extractor hood for 3 seconds to
activate the calibration mode.
3. The button on the extractor hood flashes to indicate that the calibration
mode is activated.
4. In calibration mode press the button (1) on the remote control briefly.
5. When the calibration is successful, an acoustic signal sound.
If the calibration is unsuccessful, the extractor hood returns to STAND - BY
MODE. In this case, repeat the calibration.
After 15 seconds, without further operation of the button (4), the extractor
hood also returns to STAND - BY MODE.
HOW TO OPERATE THE REMOTE CONTROL:
BUTTON: ON / OFF
❖ Press the button (1) on the remote control to switch on / off the motor of
the extractor hood.
BUTTON TO DECREASE THE POWER LEVEL / MOTOR SPEED
❖ Press the button (2) on the remote control to decrease the power
level / motor speed of the extractor hood (s. chapter 4.4 POWER LEVELS).