User manual

OSD
35 Version 1.5
Adjust sharpness of image.
Factory setting is HIGH
Possible settings are:
• HIGH: highest contour sharpness of image with most details
• MEDIUM: average contour sharpness
• OFF: contour sharpness is de-activated for soft contours with
fewer details.
Resolution Change Output
SCB-12
CHANGE OUTPUT
DVI/RGB Resolution
AUTO
Resolution Test
Ok
Cancel
Resolution and refresh rate (vertical frequency)
Factory setting is AUTO
Possible settings are:
• AUTO: automatic adjustment of optimal resolution and refresh
rate depending on the connected display device according to the
VESA standard
• Manual setting of resolution and refresh rate.
VGA/60 to 1080p/60.
Before changing the resolution with “Ok”, select the line “Resolu-
tion Test” to check capability of connected display device.
For automatic adjustment of resolution and refresh rate a full con-
nected cable is needed (DDC-lines).
More information regarding resolution and refresh rate can be
found on page 54
Selected resolution will be activated for 10 seconds, afterwards the
units switches back to previous setting. This would be helpful to
check if the connected display device is capable to show the de-
sired resolution.
Activated test procedure cannot be aborted manually, it returns
automatically back after 10 seconds.
Confirms the selected resolution and returns to previous page.
Returns to previous menu page without any change.
Detail
DVI/RGB Resolution
Resolution Test
Ok
Cancel