User manual

Go straight to the source with all your T-Max® brand remote questions: [phone]
Page 4 - 28717-01B
Scenario 2 - T-Max 3A with Wireless
In single sunbed installations, the T-Max® 1A and 3A can offer the
same control as the T-Max® Manager, eliminating the need for a
Manager. If you’re using a 1A in this manner, it must
have a chip
labelled “master” installed on its circuit board. The remote control
bypass plug must not
be used in this configuration. The 3A may be
used as a “master” with no modification.
After you have set the T-Max® 1A’s, or 3A’s, address to “0” (refer to your
T-Max® user’s guide) and the sunbed’s
address to “1”, simply connect
one G2 (with Power Injector) to
the T-Max® 3A and one G2 to
the tanning bed.
Scenario 7 - Non T-Max® Remote System wired to unit
Most non-T-Max® remote systems control the sunbed by the use
of a relay. The relay operates the sunbed by connecting and dis-
connecting a pair of wires leading from the sunbed. Refer to the
user’s manual provided with your remote system to determine if
it operates in this way. To
connect your sunbed to this
type of system a remote
interface kit is required.
Contact your place of pur-
chase to obtain the kit. The
illustration at right details a
typical connection. Follow
the instructions provided
with the kit and from the
remote’s manual to make
the necessary connections.
Scenario 4 - T-Max® Manager Series with Wireless combination
Connect one G2 (with Power Injector) to the Manager and one G2 to
a wireless ready tanning bed. The rest of the salon may be “daisy-
chained” together and connected to the wireless equipped tanning
bed, eliminating the need to wire the Manager to the tanning beds.
Scenario 3 - T-Max® Manager Series with Wireless combination 2
Wireless can be easily added to an existing salon already utilizing T-
Max®. Connect one G2 (with Power Injector) to the Manager and one
G2 to each wireless ready tanning bed. The
rest of the salon may be “daisy-chained”
together and connected to the Manager.
Scenario 6 - Single Bed wired to T-Max® 3A
In single sunbed installations, the T-Max® 1A and 3A can offer the
same control as the T-Max® Manager, eliminating the need for a
Manager. If you’re using a 1A in this manner, it must
have a chip
labelled “master” installed on its circuit board. The remote control
bypass plug must not
be used in this configuration. The 3A may be
used as a “master” with no modification.
After you have set the T-Max® 1A’s, or 3A’s, address to “0” (refer to your
T-Max® user’s guide) and the sunbed’s address to “1”, simply connect
the RJ-22 modular cables, described
in the T-Max® user’s guide, directly
into either of the smaller ports locat-
ed on the canopy and either port on
the back of the T-Max® 1A or 3A.
NOTE: A T-Max® 1A with a
“master” chip can be substituted
for a 3A.
Scenario 5 - T-Max® Manager Series with wires
As always, this tanning bed is fully compatible with a wired T-Max®
system. Simply connect the RJ-22 modular cable(s), described in the
T-Max® Manager manual, into the remote port(s) located on the back
of the canopy and follow the instructions that came with your remote
system.