User manual

Lay the bench upside down on the
floor. Locate the two stand legs.
1
Remove the six 5/16” x 1” bolts and
5/16” washers installed in the bench.
Attach the stand legs, with the four small
skirt mounting holes toward the back, by
installing the center bolt first. You may
have to gently push the sides of the legs
in to align holes. Tighten with the Allen
wrench.
2
SKIRT MOUNTING HOLES
Page 2 - 28717-01B
Assembly Procedures
(ELECTRICAL CONNECTOR
INDICATES BACK OF BENCH)
SHORT BOLT
Turn bench over. Install hinge brackets to ends of bench such
that the short boss engages the stud above the bolt hole, and
the long boss engages the hole below the bolt hole. Secure
using 5/16” x 1” Allen-head bolts and 5/16” metal washers.
Tighten bolt snug, then an additional half turn.
7
STUD
While the bench is upside-down attach
the triangular skirt mounting brackets.
Locate the two brackets and attach them
as shown with two #10-32 x 1/2” screws.
Make sure the threaded inserts point
toward the stand legs.
3
Attach the side skirts to the mounting brackets
with two #10-32 x 1/2” screws from inside the
skirt and into the brackets. The rounded part of
the side skirts points toward the front of the bed.
4
The front skirt panel is held in place by adhesive backed
Velcro® strips. Peel off the backing paper from the two
large pieces and adhere them to the stand legs. Stick a
narrow strip on each side of the side skirts. The last piece
attaches the tab on the top of the front skirt to the bottom
of the bench cover.
5
Peel the remaining backing paper from the
Velcro strips and press the front skirt in place.
6
Place the bushings
into hinge brackets.
8
Lift the canopy and hold it
between the hinge brackets.
9
Insert 5/16” x 1 1/2” bolts with nylon
washers into both hinge brackets.
Tighten bolts into the endcap threaded
inserts until snug, then an additional
half turn. Do not overtighten to avoid
damaging threaded inserts.
10
SCREWS
VELCRO STRIPS