User Manual

8
40 mm
Then slide the fence firmly up
against the side of the board
and secure it with the fastening
screw. Now the fence is preci-
sely adjusted to the centre of
the dowel and of the board.
To adjust the fence of the Do-
welmaster to the dowels already
drilled, loosen the fastening
screw and insert the dowels into
the corresponding drill bush of
the Dowelmaster.
Clamp the face board board
with the dowels on to the board
that is to be drilled and slide
the Dowelmaster with the
guide groove over the dowel.
The fence then butts firmly
against the lower edge of the
board.
Face joints can also be made
rapidly and extremely precisely
with the Dowelmaster.
Position the Dowelmaster on a
dowel, slide the angle fence
against the side of the board,
and tighten the screw.
Clamp the two boards into the
workbench. Slide the Dowel-
master with the guide groove
over the dowel, and drill.
T joints with the Dowelmaster
Making face joints with the Dowelmaster
Mark the centre of the shelf on
the side board and clamp the
shelf at a distance of 40 mm.
When T joints (e.g. for centre
shelves) are to be made, the
Dowelmaster is used without
the angle fence.
Then slide the Dowelmaster
with the guide groove over the
dowel, and drill. After this, app-
ly glue to the boards.
The Dowelmaster
T and face joints
Duebelf_0514.indd 8 17.06.14 15:28