User Manual

16
Making T joints with the Multi-purpose Wood Jointer
Then lay the top or bottom
flat with the outside edge on
the workbench, and cut the
slot into the face of the board.
Side walls and floors are joined
together in a moment by this
method, and fit together per-
fectly first time.
Align the bottom precisely to
the side wall using an angle,
and mark the position.
Then turn down the floor, align
it to the marking, and clamp it
tight. Apply the machine to the
edge of the wood ...
... and cut the slot into the side
wall. Then lay the machine flat
and cut the face edge.
If the bottom shelf is to be posi -
tioned higher, e.g. for a base-
board, the machine is supported
with a board of the appropriate
thickness.
For thinner boards (< 18 mm),
in order for the slot to be loca-
ted roughly in the centre of the
edge a small plywood board is
laid under the edge of the
wood ...
... and plywood of the same
thickness is laid under the
board when cutting the coun-
ter-slot, e.g. underlay 12 mm
wood thickness with 4 mm
plywood.
Tips and tricks with the Multi-purpose Wood Jointer
Position the side walls side-on
against the clamped board and
cut the biscuit slots.
The multi-purpose Wood Jointer T joints
Duebelf_0514.indd 16 17.06.14 15:28