User Manual

15
5
6
4
8
1
2
7
3
20 10 0
Making corner joints with the Multi-purpose Wood Jointer
The Multi-purpose Wood Jointer
The Multi-purpose Wood Jointer is an attachment
for an angle grinder, which, after the clamping
nut and wheel flange are removed, can be faste-
ned directly into the screw opening (1). Then the
lateral machine brackets (2) are fastened with the
screws provided (3) to the two grips of the angle
grinder. The motor of the angle grinder drives a
4 mm thick carbide tipped saw blade (4). This can
be moved forward out of the housing (5) using a
slider. The extent to which the saw blade can be
slid out is controlled with the depth setting (6).
An angle bracket (7) for 90 and 45 degrees can
be attached to the housing.
Identify your boards with a
triangle as side walls or as
top or bottom boards.
Then clamp a board vertically
onto the workbench. The board
must be precisely at right an-
gles to the work surface.
The biscuit sizes
Biscuits come in three sizes: types 0, 10 and 20.
The biscuit size to be used depends on the
thickness of the wood boards that are to be
joined. The rule of thumb is:
type 0 biscuit = 10 – 12 mm wood thickness
type 10 biscuit = 13 – 15 mm wood thickness
type 20 biscuit = from 16 mm wood thickness
These biscuit sizes are preset on the depth set-
ting (6) and can be selected by turning the rapid
adjustment to the required size.
Depending on the board size,
it may be necessary to insert a
dowel in the centre in addition
to the two outer biscuits.
The multi-purpose Wood JointerCorner joints
Duebelf_0514.indd 15 17.06.14 15:28