User Manual

12
Making corner joints with the Dowelling Jig
Making T joints with the Dowelling Jig
Lay the Dowelling Jig on the
side wall and slide the left side
stop against the left board
edge.
Then fasten the Dowelling Jig
to the board with screw clamps.
Take care that the sliding drill
head ...
... engages in the same holes
of the Dowelling Jig as for the
drilling of the face holes. The
holes are numbered for this
purpose.
The Dowelling Jig is distinguis-
hed by great precision and
simple handling, which make
exact dowelling just really easy
even for the inexperienced.
Since the angle fence was
set to 20, a centre line at a
distance of 10 mm must be
drawn from the bottom.
Remove the angle fences
and align the Dowelling Jig to
the centre line, and fix the
whole assembly with clamps.
Again take care that the sli-
ding drill head is engaged in
the same holes of the Dowel-
ling Jig as it was for drilling
the face holes.
When assembling, pay attention
to the correct position of the se-
parate
components, since the
dowels are not located preci-
sely in the centre of the edge.
You no longer need any large
collection of machines or acces-
sories for constructing your own
furniture. Power drill and Dowel-
ling Jig are quite sufficient!
The Dowelling Jig Corner and T joints
Duebelf_0514.indd 12 17.06.14 15:28