Precautions » Please read this manual carefully before operation and keep it for future reference. It will ba helpful should you encounter any operational problem. » Improper installation wil void the manufacturer's warranty. The installation instructions do not apply to al types of vehicles and are written as gui system.
» Only clean the device with a soft dry cloth, for tough dirt, apply some neutral detergent diluted parts water to a soft cloth. » Note that alcohol, thinner, benzene, stc could cause damage to the paint or costings. » Avoid making contact with the Lens as damage may be caused. » The video recordings made by this Digital Video Recorder are intended for personal use only. » Whilst driving, do not adjust the controls of your device as this s a distraction to driving.
Installation Warning Please MAKE SURE ta connect all cameras and wires BEFORE power ON the Mirror Screen, otherwise, the camera cannot work properly. Please follow the Instructions blow for the first-time Installation of the Stream Media Mirror Dash Camera. Its designed to ba fitted ta the existing rear view mirror using the straps.
Insert Micro SD Card Notice: » Notice:Use your nail to push the memory card into a slot if required. Aka Cara that the card has slicked into the slot, a second push inwards wil release the memory card. » Do riot remove or insert the memory card when the Mirror Dash Cam is muted on. This may damage the memory card. » Take care wham removing the SD card from the Mirror Dash Cam when it is installed in the vehicle. Due to the card slot mechanism, the card will spring from the slot when released.
Mount the Mirror Dash Cam Step 1: Attach the upper end of the straps te the retaining hooks on the top of the rear-view mirror. Step 2: Extend the straps around the back of the rear-view mirror and attach them to the bottom retaining hooks.
Notice: » The straps have been designed so they can be cut down to give further size options, ss required. » The straps should be a tight fit when fitted, thus ensuring the Stream Media Mirror Dash Camera is securely fitted to the existing rear-view mirror.
» Attach the front camera and the in-car camera to a suitable position on the front windshield.
Install inside the car Please choose type 1 bracket to mount the rear camera if you'd like to install it inside your vehicle. Install outside the vehicle Please choose type 2 bracket to mount the rear camera if you'd ike to install it outside your vehicle.
Rear Camera Installation Notice: » Make the connection first and ensure the machine work well before installing. » Neap away with the driving operation and the active part of the car. Da not gst caught by screws or seat gaps. » When riling holes in car, please do not break the vibrator, tench and wires. » Before attaching the double-sided tape, please remove stain or oil with alcohol cleaner from the surface.
Wiring Images mn oo a ‘Consomme the re ver wh. Cn, NOTICE: The Mini USB interface on the right is sad to connect the car charger, and the Type-C interface on the left is used to connect the 3-in-1 connector.
Wire Layout in the Vehicle Stop 1: The car charger is connected to the cigar socket. Step 2: Plug the front camera and the in-car camera into the 3-in-1 Gyps-C connector and install the front camera and the In-car camera at a suitable position on the front windshield.
Step 3: Connect the rear camera cable to the 3-in-1 Type-C connector, and hide the rear camera cable inside the vehicle.
@ Screen @ Speaker @ Strap Retaining Hooks ® Power Button © Reset Hole ® 3in 1 Ty pa-C Port @ GPS Port ® Micro SD Card Slot ® Power Supply Port © Front Camera © In-car Camera ® Rear Camera
® Recording © Stan/ Stop Recording ® Speed @ Date &Time ® Snapshot © Driving Direction @ Settings @ Image Switch @ Screen Brightness Adjustment @ File Playback ® Lock/Unlock Notice: You need to pause recording before entering into settings.
«Loop Recording: Set the video recording loop time. 1 minute -2 minutes “3 minutes Sound Record: Tum on/off audio recording. « Auto-Rec: After starting the automatic recording, if there is no interactive operation, it will automatically enter the recording mods.
* Event Cycle: After the Event Cycle is enabled, when the locked video file reaches 20% of the memory card capacity, subsequent locked videos will overwrite the oldest locked video to save, thereby maintaining the healthy capacity of the memory card. *Video Time Lapse: Set the time-lapse recording of the vehicle (This gesture requires hard-wired kit to activate). timeliness Power Off: Turn on/off the time-lapse recording function.
» Beep: Turn on/off the key voice. » Mirroring Front View: Tur on/off the mirror view of the front camera. * Mirroring Rear View: Tur on/off the mirror view of the rear camera. * Mirroring Room View: Turn on/off the mirror view of the in-car camera. » Clock Settings: Set the current time and date. This function allows for manual time setting If ‘GPS iz nat available. Once a GPS signal is received the time and date will update automatically.
» LCD Power Saver: Set the screen saver time. Off 1 min 2 min 3 min » G-Sensor sensitivity: Select the sensitivity of the G-Sensor or tum it off The locked files will not be overwritten. Please copy important locked files to your computer for storage, and format the SD card regularly.
» Parking Monitoring: Start the parking guard function {according ta the preset G-Sensor the emergency voids recording is automatically started after the vehicle is shaken, sensitize this function requires a hard-wired kit to be used normally), off High Middle (Recommend preset levels). “Low »Value: Set the volume. * GSP Status: Show the Longitude, Latitude, and other GPS information. «Time Zone Select: Select the time Zane of your location. The system wil set a date and time according to the GPS location.
«Speed Unit: MPH KM «GPS Display: Turn on/off the display of GPS information «Time Format: Set the Hours time display format according to usage habits. © Varese Line: Ta display the reversing guideline, you need to connect the trigger wire (red wire} at the end of the rear view camera to the positive pole of the reverse lamp. * Reversing Line Correction: You can adjust the reversing guideline according to the actual environment. « Reset Setup: Restore the initial settings.
« Format SD-Card: Clear all Micro SD card data files (please save important video files in advance and format the Micro SD card regularly} » FW Version: View the firmware version information. Brightness Adjustment Touch the pointed area fist, a scroll bar will come out, than slide to left or adjust the brightness.
Data Playback Ta select a video or phat for playback, press the 5) button.Slide ta select the desired file form the list and then press the fie name to start playback.
i Bollocking the fle. W Display the previous videotape. Deletes the fli. ¥+ Start or pauses the playback. ~~ ¥ Display the next videophones. #4 Re fum to the list. Review GPS Data with Software [ CAR DVR PLAYER | By using the file playback software [ CAR DVR PLAYER |, you can record and playback in system with Google Map etc. also you can check all drive information such as Time, Location, Spade, and so an.For the first time use, please download the file playback software [ CAR DVR PLAYER].
® Playback Screen: Playback screen display @ Scroll Bar: Click, can speed forward or back © GPS Information: Including Latitude, Longitude, Speed @ Map Display: Show ths location of the car on the map © Playlist The data lst for playback ® G-sensor Data @ Play Pause Trouble Shooting » The power does not turn on Please sack that the cigarette power cable is not damaged, and whether the indicator light of the cigar plug is on.
* Stop recording oon as it start recording Please check that the micro SD Card is inserted, and the capacity af the Mira SD card. Time display ia incorrect after setting Please ensure to chose the correct time zone when GPS antenna is connected. Warranty & Support * Warranty Any quality issues, year warranty * Support If you have any questions about the product functions of installation, please foe! free to contact us through amazon or service. inquiries will be answered within 6-12 hours of the waking day.
» Your opinion matters We work hard day and night to improve the quality of our products,services and th user experience. Lease fell free to contact our company if you have any valuable suggestions and ‘shipment for product improvement. Expecting your vice. * After sales Support E-mail: service Whatshisname No.
