Warming Drawer Installation Guide
WARMING DRAWER Contents 3 Warming Important Note Drawer 4 Specifications 7 Installation Troubleshooting 7 Features and specifications are subject to change at any time without notice. Visit wolfappliance.com/specs for the most up-to-date information. To ensure this product is installed and operated as safely and efficiently as possible, take note of the following types of highlighted information throughout this guide: IMPORTANT NOTE highlights information that is especially important.
WARMING DRAWER Product Information Important product information including the model and serial number are listed on the product rating plate. The rating plate is located on the left front floor area of the inner cabinet. The drawer must be open to view the rating plate. Refer to the illustration below. If service is necessary, contact Wolf factory certified service with the model and serial number.
SPECIFICATIONS Installation Requirements Electrical The warming drawer must be installed with a Wolf drawer front, available through an authorized Wolf dealer. For local dealer information, visit the find a showroom section of our website, wolfappliance.com. Specific installation instructions are included with the drawer front. Installation must comply with all applicable electrical codes. The warming drawer can be installed in a standard or flush inset application (excludes L series drawer front).
SPECIFICATIONS Warming Drawer STANDARD INSTALLATION 23" (584) OPENING DEPTH TOP VIEW ANTI-TIP BLOCK 91/8" (232) OPENING HEIGHT E 28 5/8" (727) OPENING WIDTH SIDE VIEW FRONT VIEW NOTE: Location of electrical supply within opening may require additional cabinet depth. wolfappliance.
SPECIFICATIONS Warming Drawer FLUSH INSET INSTALLATION A DRAWER FRONT DEPTH 24" (610) FLUSH INSET DEPTH FINISHED CLEATS* TOP VIEW ANTI-TIP BLOCK 10 5/8" 3/4" (19) (270) FLUSH INSET HEIGHT** 3/4" (19) E 3/4" (19) 30 1/8" (765) FLUSH INSET WIDTH** SIDE VIEW FRONT VIEW *Will be visible and should be finished to match cabinetry. **Dimension provides minimum reveals. NOTE: Dimensions provided allow for 1/4" (6) reveal for proper air flow.
INSTALLATION Preparation Troubleshooting Remove and recycle packing materials. Do not discard the package containing two screws provided for installation. IMPORTANT NOTE: If the warming drawer does not operate properly, follow these troubleshooting steps: Install an anti-tip block against the rear cabinet wall. Verify screws are adequately secured and do not penetrate electrical wiring or plumbing. • Verify electrical power is supplied to the warming drawer.
WOLF APPLIANCE, INC. P.O. BOX 44848 MADISON, WI 53744 9001600 REV-B WOLFAPPLIANCE.COM 9 / 2014 800.222.
