Specifications

6
WOLF WARMING DRAWER
28
1
/2" (724)
33" (838)
RECOMMENDED CABINET WIDTH
30"min (762)
28
5
/8" (727)
WARMING DRAWER
OPENING WIDTH
E
5"
(127)
4"
(102)
ALLOW FOR
5
/8" (16)
OVERLAP OF
DRAWER FACE
ON ALL SIDES
NOTE: Refer to the built-in 30" (762) single oven specifications for electrical location.
30-INCH OVEN
ROUGH OPENING
24"min (610)
CABINET DEPTH
2
3
/8"
(60)
ANTI-TIP BLOCK APPLICATION
9
1
/8" (232)
OPENING
HEIGHT
23
7
/8"min (606)
OPENING DEPTH
27
3
/16"
(691)
24"min
(610)
2"(51) x 2"(51)
ANTI-TIP BLOCK
PLATFORM APPLICATION
24"min (610)
CABINET DEPTH
7
/8"
(22)
9
1
/8" (232)
OPENING
HEIGHT
23
7
/8"min (606)
OPENING DEPTH
27
3
/16"
(691)
24"min
(610)
7
/8" (22)
PLATFORM
STAINLESS STEEL DRAWER FRONT
INSTALLATION WITH BUILT-IN OVEN
T
he Wolf warming drawer with stainless steel
drawer front may be installed below or above
a Wolf 30" (762) built-in single oven or below a
d
ouble oven, provided the warming drawer is
fully enclosed, top and bottom. Refer to the
illustration below. Also refer to installation
instructions provided with the built-in oven for
additional specifications. Dimensions will vary
according to the specific installation.
The Wolf warming drawer is designed and
agency approved for installation with Wolf
built-in ovens.
The warming drawer platform must be able to
support 200 lbs (91 kg). It must be a minimum
of 1" (25) above the toe kick to allow for the
overlap of the warming drawer trim.
Installation with Built-In Oven – Stainless Steel Drawer Front
IMPORTANT NOTE: Additional clearance
between warming drawer and oven openings
m
ay be required. Check that oven supports do
not obstruct the interior dimensions required
for the warming drawer.
When the warming drawer is installed below
a
built-in oven, a minimum of 2
3
/8"
(60)
between warming drawer and oven openings
is required for placement of the anti-tip block.
To allow the warming drawer trim and the
built-in oven trim to meet, a
7
/8" (22) platform
may be used to separate the two openings.
This will act as the support platform for the
oven and the anti-tip device for the warming
drawer. Both applications are shown in the
illustration below.
IMPORTANT NOTE: When the warming
drawer is installed above a built-in oven, a
7
/8" (22) platform is required to allow for
clearance of overlaps.