Specifications

17
Dimensions in parentheses are in
millimeters unless otherwise specified.
INSTALLATION INSTRUCTIONS
Location of
side hole
W
ar
ming drawer installation
INTEGRATED FRONT PANEL
INSTALL ANTI-TIP BLOCKING
Install a 2" (51) x 2" (51) or 2" (51) x 4" (102)
anti-tip block against the rear cabinet wall as
s
hown in the installation illustration for your
specific installation on pages 9–11.
INSTALL WARMING DRAWER
Turn power off to the electrical outlet. Slide the
left corner of the warming drawer into the
o
pening. If the electrical outlet is installed
inside the opening, plug the power cord into
the outlet. The excess cord should be coiled
b
ehind or beside the unit. If the outlet is
located in an adjacent cabinet, thread the
power cord through the hole in the cabinet
wall. Push the unit back into the opening until
the warming drawer collar meets up with the
recessed cleats and platform. Make sure the
power cord does not get trapped under the
warming drawer.
Open the drawer to its full extension. Drill pilot
holes in each side hole, one located toward
the front on each side of the warming drawer.
Install the wood screws provided with the
warming drawer. Refer to the illustration
below. Turn power back on to the electrical
outlet.