Specifications

IMPORTANT NOTE: When installed outdoors,
A ground fault circuit interrupter (GFCI) is
r
equired to reduce the risk of electrical shock.
Y
ou must follow all National Electrical Code
regulations. In addition, be aware of local
codes and ordinances when installing your
s
ervice.
12
WOLF WARMING DRAWER
ELECTRICAL REQUIREMENTS
The Wolf warming drawer requires a separate,
grounded 120 V AC, 50/60 Hz power supply
a
nd must be connected to an individual
properly grounded branch circuit and
protected by a 15 or 20 amp circuit breaker or
t
ime delay fuse.
I
MPORTANT NOTE:
T
he warming drawer is
equipped with a power supply cord with a
3-prong grounding plug, which must be
plugged into a mating 3-prong grounding-type
electrical outlet to minimize the possibility of
electric shock.
The location of the outlet is not critical, but
must be within reach of the 6' (1.8 m) power
cord. If it is placed behind the unit, make sure
the outlet is flush with the back wall. For
location of the electrical outlet, refer to the
installation illustration for your specific
installation on pages 5–11.
The electrical outlet can be located in an
adjacent cabinet within reach of the power
cord. If the outlet is located in an adjacent
cabinet, you will need to drill a 2" (51)
diameter hole in the cabinet wall for the power
cord.
If two warming drawers are installed side by
side, they can operate from the same electrical
outlet. A 30 amp circuit breaker is required for
this installation.
Do not use an extension cord or two-
prong adapter. Electrical ground is
required on this appliance. Do not remove
the power supply cord ground prong.
The electrical outlet must be checked by
a qualified electrician to be sure that it is
wired with the correct polarity. Verify
that the outlet provides 120 V AC and is
properly grounded.
IMPORTANT
NOTE
You must follow
all National
Electrical Code
regulations. In
addition, be aware
of local codes and
ordinances when
installing your
service.