installation guide

wolfappliance.com | 9
Wiring Connections
INTERNAL BLOWER WIRING
1 Remove the top cover of the electrical box by extracting
two screws. Refer to the illustration below.
2 Remove the two existing wires from the left side of the
terminal block, then transition them to the right and
secure. Refer to the illustration below.
3 Place all wiring connections inside the electrical box and
reinstall the cover. Make sure all wires are secure and not
pinched between the cover and electrical box.
4 Secure the junction box supplied with the hood to the
wall, then connect to the (Romex
®
) power supply from
the home. Once the connection has been made, insert
the plug into the receptacle on the hood.
MOVE WIRES
HERE
COVER
BLUE
BROWN
BLUE
BROWN
TO INTERNAL
BLOWER
BLUE
BROWN
Wiring location. Internal blower wiring.
INSTALLATION
IN-LINE / REMOTE BLOWER WIRING
1 Remove the top cover of the electrical box by extracting
two screws. Refer to the illustration below.
2 Remove one of the round knockouts using a at blade
screwdriver.
3 Insert Romex
®
wire from the blower through the
knockout and secure using an approved cord stain relief.
4 Connect white to blue, black to brown and green to
ground. Refer to the illustration below.
5 Place all wiring connections inside the electrical box and
reinstall the cover. Make sure all wires are secure and not
pinched between the cover and electrical box.
6 Secure the junction box supplied with the hood to the
support frame, then connect to the (Romex
®
) power
supply from the home. Once the connection has been
made, insert the plug into the receptacle on the hood.
KNOCKOUT
COVER
WHITE
BLACK
GREEN
GROUND
BLUE
BROWN
TO IN-LINE/REMOTE
BLOWER
BLUE
BROWN
Wiring location. In-line / remote blower wiring.