Installation Guide

8 | Wolf Customer Care 800.222.7820
Hood Preparation
Remove the lters prior to installation. To remove, press
the lter upward and rotate the bottom. Remove the grease
cups from the bottom edge of the hood. Refer to the illustra-
tion below.
SPECIFICATIONS
Electrical Requirements
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustration
below. A separate circuit servicing only this appliance is
required.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 120 VAC, 60 Hz
Service 15 amp dedicated circuit
E
6"
(152)
5"
(127)
30" (762) TO 36" (914) BOTTOM EDGE TO COUNTERTOP
Electrical location
Rating plate location
RATING PLATE
SIDE VIEW
SPRING
FILTER
GREASE
CUP
Filters