Installation Guide

wolfappliance.com | 13
INSTALLATION
Complete the Installation
FILTERS
Install the grease cups at the bottom rear edge of the hood.
Orient the lters with the lines running vertically. To install,
place the top edge of the lter against the spring, press
upward and rotate the bottom. Refer to the illustration
below.
LIGHT BULBS
A suction-cup-style light bulb changer is provided with
the hood. To install, use the changer to push the bulb into
the receptacle and rotate counterclockwise one-quarter
turn. Refer to the illustration below.
For 27"
(686) deep wall hoods, install the heat lamp bulbs
(not included). Use R40, 250W bulbs.
SIDE VIEW
SPRING
FILTER
GREASE
CUP
LIGHT BULB
CHANGER
Filters Light bulb installation
WOLF LOGO
To attach the Wolf logo, clean the mounting area with rub-
bing alcohol. Remove the paper backing, position the logo
parallel with the bottom of the hood, then press into place.