Installation Guide

wolfappliance.com | 11
24"/27" Deep Wall Hood
INSTALLATION
4 The hood is shipped with the transition attached upside
down inside the top of the hood. Refer to the illustration
below.
5 Separate the transition from the hood by removing the
hold-down brackets. Remove the shipping material from
the transition.
6 Mount the transition and hold-down brackets to the top
of the hood using the existing screws. Refer to the illus-
tration below.
7 For internal blowers, install the blower prior to mounting
the hood. Refer to the instructions provided with the
blower.
TRANSITION
HOLD-DOWN
BRACKET
TRANSITION
Transition position (shipping) Transition mounting
wolfappliance.com
| 11
8 Place the hood on the mounting brackets. Secure with
the provided screws through the mounting holes on the
back panel. If additional support is required, drill supple-
mentary holes through the back panel and secure with
screws and washers.
9 Insert Romex
®
wire(s) into the electrical box knockout
and secure with a UL or C/UL approved connector (not
provided).
10 Connect the ducting to the transition and secure with
duct sealing tape.
INSTALLATION
MOUNTING STRIP
ELECTRICAL
BOX
(INSIDE HOOD)
Hood installation Electrical box location