Installation Guide

wolfappliance.com | 9
Low-Profile Wall Hood
INSTALLATION
WARNING
Wall framing must be able to support the weight of
the hood and internal blower, if applicable.
1 Refer to the illustration for typical wall framing. Addi-
tional framing or blocking is required in the mounting
bracket location.
2 Position the mounting brackets on the wall as shown
in the illustration below. Secure the brackets to the wall
framing and blocking with the provided screws and
washers.
26
1
/4" (667)
MOUNTING BRACKET
CENTERS
7
1
/4" (189)
TO BOTTOM
OF HOOD
BLOCKING
C
L
Mounting bracket location
1 Install the transition. For an internal blower, the transi-
tion is included with the blower. For in-line and remote
blowers, a transition is required (not provided). Refer to
the illustration below.
2 Lift the hood into position and insert Romex
®
wire(s)
into the electrical knockout and secure with the pro-
vided connector.
3 Secure the hood to the wall blocking and structure with
the provided screws and washers.
4 Connect the ducting to the transition and secure with
duct sealing tape.
TRANSITION
ELECTRICAL
BOX
(INSIDE HOOD)
Transition (internal blower) Electrical box location
Installation
3
4
5
6