Specifications

wolfappliance.com | 69
WOLF CUP WARMER
SPECIFICATIONS
INTERIOR CAPACITY CU FT (L)
Cup Warming Drawer .8 (22)
INTERIOR DIMENSIONS W H D
Cup Warming Drawer 17" (432) 4" (102) 20" (508)
Planning Information
The cup warming drawer can be installed in a standard or
ush inset application.
Finish the edges of the opening. They may be visible when
the drawer is open.
For ush inset installations, a minimum
1
/8" (3) reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
To install a coffee system above a cup warming drawer,
one opening for both units must be specied. To achieve
the minimum reveal between units, place the coffee system
support rails on top of the cup warming drawer, then secure
the rails to the sides of the cabinet. Any material between
the units will increase the horizontal reveal.
INSTALLATION REQUIREMENTS
BASE SUPPORT MIN
Cup Warming Drawer 75 lb (34 kg)
TRIM OVERLAP
Top 0 " (0)
Bottom 0" (0)
Sides
11
/16" (18)
ELECTRICAL
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustrations
on the following pages. A separate circuit, servicing only
this appliance is required. A ground fault circuit interrupter
(GFCI) is not recommended and may cause interruption of
operation.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 120 VAC, 60 Hz
Service 10 amp dedicated circuit
Receptacle 3-prong grounding-type
Power Cord 3' (.9 m)
21" (533)
BEHIND FRAME
5
1
/2"
(140)
7
/8"
(22)
DRAWER
FULL EXTENSION
19"
(483)
23
1
/2" (597)
Cup Warming Drawers
DIMENSIONS
RANGES / RANGETOPSOVENS / WARMING DRAWERS OUTDOOR GRILLS VENTILATIONCOOKTOPS / COFFEE SYSTEMS