Setup guide

Wolf Cinema Quick Setup Guide
3
Connect all sources to the inputs of the scaler.1.
Connect a HDMI cable from the video output on the scaler to input 2(DVI) in the projector.2.
Connect power to the AC input using the provided power cable. The scaler will automatically 3.
turn on. If a Red LED is shown on the right side of the front panel, the Scaler is receiving AC
power but no signal is detected. If a Blue LED is shown, the Scaler is receiving AC power
and a good video signal is being detected. No LED indicates there is no AC power within
the scaler.
All projectors come with 10 Channel Memories that are pre-set for the scalers inputs, the
VariScope lens feature and VariScope 2.35 Anamorphic lens congurations; all based on the
installation specications supplied by the dealer. Once the 10 Channel Memories are calibrated
at the installation, those channel memories can be copied to the remaining empty Channel
Memory slots (11-99).
See the entire Channel Memory chart at end of this Quick Setup Guide.
Channel Memory Setup
Channel 01 HDMI 1 1.78
Channel 02 HDMI 1 1.85
Channel 03 HDMI 1 2.20
Channel 04 HDMI 1 2.35
Channel 05 HDMI 1 2.40
Channel 06 HDMI 1 2.35a
Channel 07 HDMI 1 2.40a
Channel 08 HDMI 1 2.60a
Channel 09 HDMI 1 2.67a
Channel 10 HDMI 1 2.70a
1
2
Service
GPIORS-232
AC Input 110-240V, 50/60HzIR Control
H
V
Component 2 / RGBHV
Component 1
Video
S-Video
HDMI 1 HDMI 2 HDMI 3 HDMI 4 HDMI 5Video / Audio Audio
Y B-Y R-Y
Y B-Y R-Y
Sync
Output
Connecting the Scaler
The Projector
Channel Memories