Setup guide

Wolf Cinema Quick Setup Guide
2
Before installing any lens, be sure the projector is off. If the projector has been running, be sure
to let it cool down completely. Ensure the front lens cap is on during installation.
NOTE: Remove the small rear lens cap before installing!! Keep the large front cap on.
Electrical Connector:1. Line up the male connector on the lens with the female connector
on the slide assembly.
Insert Lens:2. Align the Tabs on the lens plate lock with the slots on the lens retainer ring.
The lens should slide in about ½”.
Rotate Lens:3. Rotate the lens clockwise until the tabs are tightly secured and the lens
release button locks the lens in place.
Front lens cap
Installing the
Primary Lens
Lens release
Lens retainer ring
Projection Lens*
Male connector assembly (on lens)
Female floating connector assembly
(on lens mount)