Specifications

9
MODULE INSTALLATION
Attach the foam strip to the underside of the
module frame. Refer to the illustration below.
Gently lower the steamer module into the cut-
o
ut area in the countertop and center. Check
that the front edge of module is parallel to the
front edge of the countertop. Check that all
r
equired clearances are met.
To attach the brackets to the sides of the
module, insert the clip into the rectangular
punchout in the pan, and push down. Install
the clamping screw into the bracket and
tighten until the screw contacts the underside
of the countertop. Do not overtighten screws.
Refer to the illustration below.
IMPORTANT NOTE: Do not use caulk or
silicone to seal the module to the countertop.
The unit must be readily removable for
service.
BEFORE OPERATING
Read the entire Wolf Steamer Module Use &
Care Information included with the module.
I
mportant safety, service and warranty
information is contained within the book.
Thoroughly clean the stainless steel steamer
basin and insert pans with mild soap and
w
ater before use.
MODULE
FOAM
STRIP
3
1
/2" (89)
CLAMPING
SCREW
MODULE
COUNTERTOP
BRACKET
CLIP
Foam strip Installation brackets
INSTALLATION INSTRUCTIONS
Never operate the steamer module
without water, damage to the unit may
result. Water or liquid must be added to
the steamer basin before turning the
module on. Never use oil, damage to the
unit may result.