Specifications

6
MULTIPLE COOKTOP INSTALLATION
I
MPORTANT NOTE:
I
f the steamer module is
to be used with a combination of additional
cooktop units or modules with a filler strip, the
c
ut-out width is calculated by adding the corre-
sponding units' cut-out dimensions plus 1
1
/4"
(32) for each additional unit.
When multiple units are installed side by side,
each unit must have its own separate recom-
mended electrical circuit.
When two or more modules are installed
together, an integrated module filler strip
(IFILLER/S) is recommended. If a downdraft
system is also installed, an integrated module
support for downdraft ventilation (ISUPPORT)
is required (Model DD30 only). Contact your
Wolf dealer for information on accessories.
IMPORTANT NOTE: Review specific
installation instructions for product to product
capabilities.
WOLF STEAMER MODULE
INSTALLATION SPECIFICATIONS
DRAIN CONNECTION
I
MPORTANT NOTE:
T
he steamer module
must be installed with a drain connection and
access to the drain through the base cabinet.
For the drain connection, the
5
/8" (16) outlet
from the valve will accept a drain hose that
must flow downward to and tie into an
existing sink drain, or a separate drain with a
freefall may be installed. Following local
building codes, your plumber will dictate how
to plumb the unit. As a third option, the
consumer will supply a heat resistant bucket
for drainage in the location of the drain outlet.
Refer to the illustration on page 5 for location
of the drain outlet.
2
1
/2"min
(64)
FRONT OF COUNTERTOP
19
1
/4"
(489)
CUT-OUT
DEPTH
29
1
/4" (743)
TWO MODULES WIDTH
44
1
/2" (1130) THREE MODULES WIDTH OR
44
1
/4" (1124) 30" COOKTOP AND ONE MODULE
59
3
/4" (1518) FOUR MODULES WIDTH OR
59
1
/2" (1511) 30" COOKTOP AND TWO MODULES OR
50
1
/4" (1276) 36" COOKTOP AND ONE MODULE
14"
(356)
CUT-OUT
WIDTH
Countertop cut-out dimensions for installation of multiple cooktops
This steamer module must be installed
at least 15" (381) away from a Wolf fryer
module, as contact between water and hot
oil may cause burns from steam and hot oil.
If there is no fixed drain connection, use a
heat-resistant receptacle with a minimum
2
1
/ 2 -gallon (7.6 L) capacity. The doors of
the base cabinet must be locked.