Coffee System Design Guide REVISED 2/2022
Coffee System Coffee System Make professional-quality coffee, espresso, cappuccino, latte, and more. The Wolf coffee system automatically steams and foams the milk perfectly. The water temperature and brew strength are adjustable. It uses either whole-bean or ground coffee. The design pairs beautifully, either side-by-side or in a tower application, with other Wolf products such as the convection steam oven. The coffee system can be installed in a standard or flush inset application.
Coffee System Coffee System DIMENSIONS 7/8" (22) 17 7/8" (454) W WIDTH WIDTH 18" (457) BEHIND FRAME UNIT FULL EXTENSION 181/4" (464) W 24" Model 231/2" (597) 30" Trim 297/8" (759) wolfappliance.
Coffee System Planning Information The coffee system can be installed in a standard or flush inset application. Trim kits are available for vertical, single and horizontal configurations. All 30" trim options are based on model EC24/B. There are no trim options for model EC24/S. The sides of the cabinetry opening must be adequate to support installation of the mounting slides. Refer to the illustration below. Finish the edges of the opening. They may be visible when the unit is slid forward.
Coffee System Planning Information ELECTRICAL REQUIREMENTS Installation must comply with all applicable electrical codes. Locate the electrical supply as shown in the illustrations on the following pages. A separate circuit servicing only this appliance is required. A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation.
Coffee System Coffee System STANDARD INSTALLATION 21 9/16" (548) OPENING DEPTH SLIDE SUPPORT TOP VIEW 17 11/16" (449) SLIDE SUPPORT E OPENING HEIGHT W OPENING WIDTH SIDE VIEW FRONT VIEW NOTE: 24" (610) model and model with 30" (762) trim require the same opening dimensions. OPENING WIDTH W 24" Model 221/8" (562) 30" Trim 221/8" (562) 94 | Wolf Customer Care 800.222.
Coffee System Coffee System FLUSH INSET INSTALLATION 23" (584) SLIDE SUPPORT FLUSH INSET DEPTH 7/8" (22) FINISHED CLEATS* TOP VIEW 5/16" (8) SLIDE SUPPORT 18 1/8" (460) FLUSH INSET HEIGHT** A E 1/8" (3) W FLUSH INSET WIDTH** SIDE VIEW FRONT VIEW *Will be visible and should be finished to match cabinetry. **Dimension provides minimum reveals. FLUSH INSET WIDTH W A 24" Model 233/4" (603) 13/16" (21) 30" Trim 301/8" (765) 4" (102) wolfappliance.
Warranty Wolf Appliance Residential Limited Warranty FOR RESIDENTIAL USE FULL TWO YEAR WARRANTY* For two years from the date of original installation, this Wolf Appliance product warranty covers all parts and labor to repair or replace, under normal residential use, any part of the product that proves to be defective in materials or workmanship.
WOLFAPPLIANCE.
