Design Guide

102 | Wolf Customer Care 800.222.7820
Planning Information
The vacuum seal drawer can be installed in a standard or
flush inset application. Finish the edges of the opening.
They may be visible when the drawer is open.
For standard installations, face trim will overlap stiles and
rails. Refer to the chart below.
For flush inset installations, a minimum ⁄"
(3) reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
BASE SUPPORT MIN
Vacuum Seal Drawer 75 lb (34 kg)
TRIM OVERLAP
Top 0" (0)
Bottom 0" (0)
Sides ⁄" (18)
Vacuum Seal Drawer
FILLER
A filler is required if installed below a countertop. The lid
is designed to remain open at 60°. Refer to the illustration
below.
2" (51)
2" (51)
FILLER
60°
Filler