Design Guide

120 | Wolf Customer Care 800.222.7820
Planning Information
For portable applications, Wolf grill carts are designed
specifically to fit grill models OG30, OG36, and OG42 and
the side burner. Model OG54 is designed for built-in appli-
cations only.
For built-in applications, Wolf outdoor grills and the burner
module are designed for easy placement into a built-in
enclosure. For outdoor grills, installation in a combus-
tible enclosure requires an insulating liner. For the burner
module, an insulating liner is not required. The enclosure
should be built according to specifications for your specific
installation on the following pages. If the burner module
is installed next to an outdoor grill, a minimum of 12"
(305)
is required between the units on the rotisserie motor side
and 2"
(51) on the opposite side. A rotisserie side conver-
sion kit is available from an authorized Wolf dealer.
Model BM13 does not include a tank retention system and
cannot be connected to a portable LP tank.
Optional stainless steel accessory doors and drawers are
available for built-in applications. Refer to pages 124–128.
Grill carts, insulating liners, and stainless steel doors and
drawers are avail able through an authorized Wolf dealer.
For local dealer information, visit the find a showroom sec-
tion of our website, wolfappliance.com.
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical codes.
The electrical outlet must be located within reach of the
power cord. A separate circuit servicing only this appli-
ance is required. A ground fault circuit interrupter (GFCI) is
required to reduce the risk of electrical shock.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 120 VAC, 60 Hz
Service 15 amp dedicated circuit
Receptacle 3-prong grounding-type, GFCI
Power Cord 6' (1.8 m)
Outdoor Grills/Modules