INSTALLATION GUIDE Dual Fuel Ranges
Contents Important Note Wolf Dual Fuel Ranges . . . . . . . . . . . . . . . . . . . . . . . . . 3 To ensure the safe and efficient use of Wolf equipment, please take note of the following types of highlighted information throughout this guide: Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Dual Fuel Range Specifications . . . . . . . . . . . . . . . . . . 5 Dual Fuel Range Installation . . . . . . . . . . . . . . . . . . . .
Wolf Dual Fuel Ranges 3 wolfappliance.com/specs Dual Fuel Range Installation IMPORTANT NOTE: This installation must be completed by a qualified installer, service agency or gas supplier. Wolf Dual Fuel Range Read this entire installation guide prior to installation and save for the local inspector’s reference. The homeowner should keep this installation guide for future reference.
Safety Instructions 4 IMPORTANT INSTRUCTIONS WHAT TO DO IF YOU SMELL GAS: If the information in this guide is not followed exactly, a fire or explosion may result, causing property damage, personal injury or death. • Do not try to light any appliance. • Do not touch any electrical switch. • Do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s • Installation and service must be performed by a qualified installer, service agency or the gas supplier.
Dual Fuel Range Specifications 5 wolfappliance.
Dual Fuel Range Specifications 6 Installation Requirements VENTILATION Failure to locate the range without the proper clearances will result in a fire hazard. IMPORTANT NOTE: Caution must be used in planning the proper installation of the Wolf dual fuel range to avoid fires or damage to adjacent cabinetry or kitchen equipment. Follow all minimum clearances to combustible surfaces shown in the installation illustration for your specific model on the following pages.
Dual Fuel Range Specifications 7 wolfappliance.com/specs Electrical Requirements Locate the electrical supply flush with back wall and within the shaded area shown in the illustration for your specific model on the following pages. 30" AND 36" DUAL FUEL RANGES • Power supply: 240 / 208 V AC, 60 Hz with 30 amp service. • Maximum connected load: 5.2 kW. • Total amps: 21 amps. • Supply wire minimum size: L1, L2 and ground— 12 AWG, neutral—16 AWG.
Dual Fuel Range Specifications 8 Gas Supply Requirements EXPLOSION HAZARD: Use a certified gas supply line and install a gas shut-off valve. Securely tighten all gas connections. Failure to follow these instructions can result in explosion, fire or death. IMPORTANT NOTE: The dual fuel range must be connected to a regulated gas supply. IMPORTANT NOTE: This installation must conform with local codes and ordinances.
Dual Fuel Range Specifications 9 wolfappliance.com/specs Gas Supply Requirements GAS MANIFOLD PRESSURE • Natural Gas: Standard orifices are set for 5" (12.5 mb) WC. A natural gas pressure regulator is installed. • LP Gas: Standard orifices are set for 10" (25 mb) WC. An LP gas pressure regulator is installed. • Gas Supply Pressure: The maximum gas supply pressure to the regulator should never exceed 14" (34.9 mb) WC; .5 psi (3.5 kPa) for natural and LP gas. The minimum line pressure is 7" (17.
Dual Fuel Range Specifications 10 30" (762) Dual Fuel Range INSTALLATION SIDE CABINET 13" (330) 30" (762) TO 36" (914) max TO BOTTOM OF VENTILATION HOOD** 18" (457) min 6" (152) TO COMBUSTIBLE* 6" (152) TO COMBUSTIBLE* 30" (762) OPENING WIDTH 36" (914) FLOOR TO COUNTERTOP 36 7/8" (937) TO COOKING SURFACE 10" (254) 8 1/2" (216) GAS 31/4" (83) LOCATION OF GAS AND ELECTRICAL EXTENDS ON FLOOR 13" (330) ELECTRICAL *Minimum clearance from rough opening to combustible materials up to 18" (457) abo
Dual Fuel Range Specifications 11 wolfappliance.
Dual Fuel Range Specifications 12 48" (1219) Dual Fuel Range INSTALLATION SIDE CABINET 13" (330) 30" (762) TO 36" (914) max TO BOTTOM OF VENTILATION HOOD** 18" (457) min 6" (152) TO COMBUSTIBLE* 6" (152) TO COMBUSTIBLE* 48" (1219) OPENING WIDTH 36" (914) FLOOR TO COUNTERTOP 36 7/8" (937) TO COOKING SURFACE 24" (610) 10" (254) GAS 31/4" (83) 13" (330) ELECTRICAL *Minimum clearance from rough opening to combustible materials up to 18" (457) above countertop.
Dual Fuel Range Specifications 13 wolfappliance.com/specs 60" (1527) Dual Fuel Range INSTALLATION SIDE CABINET 13" (330) 30" (762) TO 36" (914) max TO BOTTOM OF VENTILATION HOOD** 18" (457) min 6" (152) TO COMBUSTIBLE* 6" (152) TO COMBUSTIBLE* 60 1/4" (1530) OPENING WIDTH 36" (914) FLOOR TO COUNTERTOP 36 7/8" (937) TO COOKING SURFACE 31" (787) 10" (254) GAS 31/4" (83) 13" (330) ELECTRICAL *Minimum clearance from rough opening to combustible materials up to 18" (457) above countertop.
Dual Fuel Range Installation Position the Range The dual fuel range is very heavy. Use caution when lifting and moving the unit. IMPORTANT NOTE: Before moving the range, protect any finished flooring to avoid damage to the floor. Secure oven door(s) closed. The dual fuel range has rolling casters in the rear which allows for easy movement of the range by lifting the front of the unit. IMPORTANT NOTE: Do not lift the range by the oven door handle(s). This will damage the oven door and hinges.
Dual Fuel Range Installation 15 wolfappliance.com/specs Oven Door Removal IMPORTANT NOTE: Remove the oven door(s) only if it is necessary to fit the range through a tight doorway. Removal may cause damage to the porcelain oven interior or the door(s). Door removal should be done by a qualified service technician or installer. For removal, a hinge pin (supplied with the range) must be inserted in the appropriate hinge arm.
Dual Fuel Range Installation Oven Door Removal 16 Electrical Connection OVEN DOOR REINSTALLATION 1) Hold the oven door on both sides and position it with door hinges aligned with openings in the oven frame. 2) Holding the oven door at an approximate 30° angle from vertical, slide the hinges into the openings until the bottom hinge arms drop fully into the hinge receptacles. 3) Open the oven door to its fully opened position. Remove the hinge pin from the appropriate hinge arm.
Dual Fuel Range Installation 17 wolfappliance.com/specs Gas Supply Connection Range Removal Before connecting the gas supply, make sure all valves are in a closed position. IMPORTANT NOTE: All connections to the gas piping must be wrench-tightened. Do not make connections too tight, this may crack the regulator and cause a gas leak. Do not allow the pipes to turn when tightening fittings. Assemble the flexible metal connector from the gas supply pipe to the gas pressure regulator.
Dual Fuel Range Installation 18 Verify Range Operation IMPORTANT NOTE: Prior to operating the range, be sure to read the entire Wolf dual fuel ranges use & care guide included with the range for important safety, service and warranty information. SURFACE BURNERS Turn on the power supply to the range. Place the burner cap on each burner base and position the burner grates before lighting. Surface burners of the dual fuel range use electronic igniters.
Service Information 19 wolfappliance.com/specs Troubleshooting Service Information IMPORTANT NOTE: If the dual fuel range does not operate properly, follow these troubleshooting steps: If service is necessary, maintain the quality built into your dual fuel range by calling a Wolf authorized service center. • Verify that electrical power is being supplied to the range. To obtain the name and number of a Wolf authorized service center, check the contact & support section of our website, wolfappliance.
WOLF APPLIANCE, INC. P. O. BOX 44848 MADISON, WI 53744 816980 REV-A 8/ 2010 WOLFAPPLIANCE.COM 800.332.
