installation guide

12 | Wolf Customer Care 800.222.7820
TOP COVER
Plug the downdraft power cord into a grounded 3-prong
receptacle, then route beneath the appliance and away from
the heat generated by the cooktop. Check the downdraft
operation.
Once operation is veried, raise the downdraft chimney and
install the top trim using the three nuts provided. Verify the
top trim is properly aligned with the side covers. Refer to the
illustration below.
FILTERS
Remove the stickers and shipping brackets and install the
lters. Refer to the illustration below.
TOP COVER
MELT
HIGH
OFF ON
OFF ON
SIM
HIGH
OFF ON
SIM
HIGH
BRIDGE
OFF ON
SIM
HIGH
ZONE 2
CLEAR
OFF
O
ZONE 2
ZONE 3
HIGH
SIM
OFF ON
Top cover installation Filter installation
Installation
CONTROL MODULE
1 Use the template provided on the following page to mark
the holes for the mounting screws. Drill one 1
9
/16" (40)
hole in the center and two
3
/8" (10) holes for the mounting
screws.
CAUTION
Verify the scale of the template if not using the installa-
tion guide shipped with the downdraft.
2 Check the countertop thickness to make sure the
threaded studs are long enough to allow the thumbnuts
to fully engage. Thicker countertops may require the
countertop be countersunk from below.
3 Place the control module on the countertop then secure
using the two nuts provided. Once secure, install the
ground wire and nut.
4 Use the provided cable or a cable designated by the
National Electric Code, NFPA/ANSI 70 or local codes.
Connect one end of the control cable to the back side
of the control module and the other to the electrical
connection on the front of downdraft assembly. Ensure
all connections are tight.
WARNING
Do not connect to a telecommunication network.
RJ45
CONNECTOR
GROUND
RJ45
CONNECTOR
GROUND
NUT
CONTROL MODULE
COUNTERTOP
Downdraft connection Control module connection
INSTALLATION