Specifications

41
Dimensions in parentheses are in
millimeters unless otherwise specified.
WOLF WARMING DRAWERS
PLANNING INFORMATION
The Wolf 30" (762) warming drawer is shipped
without any decorative drawer front. You must
order one of three stainless steel drawer fronts
(handle included) in classic, platinum or carbon
finish or the integrated front (no handle) for a
custom wood application.
Specifications on the following pages provide
overall dimensions, rough openings and
installation options for the warming drawer with
stainless steel and integrated drawer fronts.
Note that there are significant differences to the
installation requirements for the integrated
drawer front.
An anti-tip block must be installed to prevent
the unit from tipping forward when the drawer
is opened.
The base platform for the warming drawer must
be able to support 175 lbs (79 kg). This platform
must be a minimum of 1" (25) above the toe kick
to allow for the
11
/16" (17) overlap of the
warming drawer trim.
A Wolf warming drawer may be installed below a
Wolf single or double oven, or an electric or gas
cooktop, provided the warming drawer is fully
enclosed, top and bottom. The Wolf warming
drawer may also be installed next to or above
another Wolf warming drawer. Dimensions will
vary according to the specific installation.
ELECTRICAL REQUIREMENTS
The Wolf warming drawer requires a separate,
grounded 120 V AC, 60 Hz power supply. The
service should have its own 15 or 20 amp circuit
breaker, and a grounded 3-prong receptacle
should be located within reach of the power
cord and flush with the back wall. Locate
electrical within the shaded area shown in the
installation illustrations on the following pages.
IMPORTANT NOTE: A ground fault circuit
interrupter (GFCI) is not recommended and may
cause interruption of operation.
You must follow all National Electrical Code
regulations. In addition, be aware of local codes
and ordinances when installing your service.
FRONT PANEL OPTIONS
Warming Drawer
Model WD30
Classic Stainless WDFRONT/S
Platinum Stainless WDFRONT/P
Carbon Stainless WDFRONT/B
Integrated WDFRONT/I
(accepts wood panel)
Optional drawer front panels are
ordered and shipped as sales
accessories. Stainless steel drawer
front panels include matching tubular
handle.
23
1
/16" (586)
BEHIND FRAME
29
7
/8" (759)
OVERALL WIDTH
9"
(229)
10
1
/4"
(260)
OVERALL DIMENSIONS
Warming Drawer
(stainless steel drawer front shown)
WOLF
WARRANTY
Wolf products are
covered by a two
and five year
residential warranty
(exclusions apply).
See warranty
details at the end
of this guide.
ACCESSORIES
Optional accessories
are available
through your Wolf
dealer. To obtain
local dealer
information, visit
the Locator section
of our website,
wolfappliance.com.