Q U I C K S E T U DCX-500i P G U DCX-1000i I D E DCX-1500i
Table of Contents Introduction.......................................................................................................................................................................... 1 Connecting the Projector..................................................................................................................................................... 1 Installing the Primary Lens..........................................................................................................
Introduction Wolf Cinema’s DCX line of projectors are designed to work in conjunction with the WC-Pro Scaler. The Scaler is calibrated at the factory and is to be used to route the variety of inputs it supports; 6 HDMI, 1 Component, 1 Component/RGB, 1 S-Video and 1 Composite Video. Each projector ships with 10 preset Channel Memories, which are programmed at the factory.
Installing the Primary Lens Before installing any lens, be sure the projector is off. If the projector has been running, be sure to let it cool down completely. Ensure the front lens cap is on during installation. NOTE: Remove the small rear lens cap before installing!! Keep the large front lens cap on. Lens release Lens retainer ring Projection Lens* Male connector assembly (on lens) Female floating connector assembly (on lens mount) View with Zoom Lens installed 1.
The Projector Channel Memories All projectors come with 10 Channel Memories that are pre-set for the Scaler's inputs, the VariScope lens feature and VariScope 2.35 Anamorphic lens configurations; all based on the installation specifications supplied by the dealer. Once the 10 Channel Memories are calibrated at the installation, those Channel Memories can be copied to the remaining empty Channel Memory slots (11-99). See the entire Channel Memory Structure Table at end of this Quick Setup Guide.
Copying Channel Memories 1. To select a Channel Memory to be copied, press the Menu will appear. 2. Scroll with the Up 3. The Channel Memory list from the OSD will appear. 4. Highlight the channel to be copied by scrolling with the Up 5. Once the Channel Memory to be copied is highlighted, select the Function 6. The OSD for copying the memory will appear. Please use care not to select any of the delete functions associated with this operation. 7.
GPIO Channel Memory Structure TABLE Channel GPIO Control to VariScope 2.35 Input/GPIO Selection at Scaler Channel GPIO Control to VariScope 2.35 Input/GPIO Selection at Scaler Channel GPIO Control to VariScope 2.
Wolf Cinema . 2431 Fifth Street . Berkeley . CA 94710 . Ph: 510.843.4500 . Fax: 510.843.7120 . www.wolfcinema.
