installation instructions

CONTENTS
1 Panel, front
2 Trim, side
4 Washer
4 Screw, #6 x
3
/
8
"
4 Screw, #8 x 1"
VACUUM SEAL DRAWER FRONT PANEL INSTALLATION
1
Use the #6 x
3
/
8
" screws and washers to install the side
trim.
2
For black glass and stainless steel front panels,
proceed to step 5. For custom drawer fronts, remove
the four screws from the back of the front panel
assembly.
3
Separate the filler panel from the mounting bracket.
4
Center the mounting bracket on the custom panel and
use the existing screws to secure the bracket to the
panel.
5
Open the drawer slightly.
6
Loosen the mounting screw on both sides of the
drawer front.
7
Align the drawer front tabs with the openings on the
drawer front and the lower mounting brackets with the
mounting screws.
8
Press down on the front panel.
9
Verify the brackets engaged the mounting screws.
10
Tighten the mounting screws to secure the front panel.
Vacuum Seal Drawer Front Panel Installation
wolfappliance.com 800.222.7820
9023120 REV-B 12/2018
Page 1 of 1
*9023120$REVB*