installation instructions

802781, 802782, 802783, 812340, 812341, 812342, 814020, 815837, 820395
Warming Drawer Handle Installation Instructions
812548 / Rev D / October, 2011
.666
.571
.461
.368
Max. Thread Length
Min. Thread Length
Max. Thread Length
Min. Thread Length
Figure 8. Decorative Panel Prep for Handle
C
L
24.124
C
L
25.374
26.875
Figure 7. Curved Framed Handle Dimensions
C
L
26.624
C
L
25.374
29.375
Figure 9. Curved Unframed Handle Dimensions
Curved Handles Framed & Unframed
(Kits 812340, 812341):
1. Mark custom panel to locate the drill holes using
the center-line dimensions from Figures 7 or 9.
Drill four (4) 7/32'' to 1/4'' holes.
NOTE: Countersink procedure is critical for this
application. Damage may occur to the handle if
these instructions are not followed precisely.
2. The handle mounting holes should be counter
bored (5/8'' diameter to 5/32'') so that when an
appropriate length #8-32 bolt and washer are put
in the hole, there will be a proper amount of
thread visible on the face side of the panel to hold
the handle without causing damage (See Figures
8 or 10) for the visible thread requirements.
3. Be sure that there is enough material removed
with the counter bore that the bolt head surface is
completely recessed into the cabinet panel.
4. A different length bolt or additional washers may
be required to achieve the proper amount of
shown thread depending on the thickness of your
custom panel.
5. Proceed with panel attachment instructions includ-
ed with the WWD flush mount panel kit.
Page 4 of 4
.650
.443
.733
.525
Min. Thread Length
Max. Thread Length
Min. Thread Length
Max. Thread Length
Figure 10. Decorative Panel Prep for Handle