Installation Instructions

M Series Microwave Trim Installation
wolfappliance.com 800.222.7820
page 1 of 2
9002491 REV-C 01/2016
CONVECTION MICROWAVE CONTENTS
1 Assembly, frame
1 Trim, door (stainless steel models only)
12 Screw
4 Stud, ball
4 Insert, threaded
3 Assembly, duct (bottom, rear and top)
1 Template
STANDARD MICROWAVE CONTENTS
1 Assembly, frame
1 Trim, door (stainless steel models only)
2 Screw
4 Stud, ball
4 Insert, threaded
1 Assembly, duct (bottom)
1 Template
DUCT INSTALLATION (CONVECTION ONLY)
For standard microwaves skip to step 4.
1 Insert the horizontal duct piece into the vertical piece to
create the rear duct assembly. Secure with one screw.
Refer to the illustration below.
2 Remove the existing screws from the upper right and left
rear of the microwave. Position the rear duct assembly
on the microwave and re-insert screws as shown in the
illustration below.
3 Position the three remaining duct pieces on top of the
microwave to create the top duct assembly. Secure
each piece with two screws (one per side). Insert one
screw in the top section. Refer to the illustration below.
HORIZONTAL
DUCT
VERTICAL
DUCT
Assemble rear duct.
REAR DUCT
ASSEMBLY
EXISTING
SCREW
EXISTING
SCREW
Attach rear duct assembly.
TOP DUCT ASSEMBLY
Attach top duct assembly.