recirculating vent_kit_instructions

Recirculating Ventilation Kits for Pro-Ventilation Hoods
Installing a recirculating unit assembly
will impact all aspects of hood installation
including hood location, electrical
placement and adequacy of mounting
structure.
Wolf Appliance, Inc. 800.332.9513 P.O. Box 44848 Madison, WI 53744 www.wolfappliance.com
812321 - Rev. A - 02 / 25 / 2008
Page 1
2 1/8”
4”
30” or 36”
12”
4”
Unit Measurements
Fig. 1 Recirculating Ventilation Hood
Fig. 2 Filter Replacement
Recirculating Ventilation Hood Kits are
designed for use with Wolf Pro Series Wall
Hoods
NOTE: A 500 or 600 cfm internal blower
must be used with recirculating kit.
Recirculating Ventilator Hood Install:
Consult Hood installation instructions 1.
for proper location and mounting
procedures of hood assembly.
Remove grille (according to item 1 in the 2.
fi lter replacement section).
Remove back panel in order to remove 3.
transition.
Remove transition from inside hood, and 4.
discard (transition will not be used).
Reinstall back panel if it was removed. 5.
Attach recirculating unit to the hood 6.
using (4) #8 - 18 x 1/2” self-tapping
screws (as shown in Figure 1). Screws
are inserted from the inside of the hood.
Mount hood assembly to wall according 7.
to installation instructions provided with
hood.
Filter Replacement:
NOTE: The Charcoal fi lter should be replaced every 3-4 months.
Use even pressure on grille to pull from unit. 1.
Lift up fi nger tabs on fi lter to release, then pull forward. 2.
To install new fi lter, place top edge to spring mounts and push inward 3.
to latch.
Install grille with louvers facing up, press in, using even pressure on 4.
each side. Press until latches.
All Recirculating Units Contain:
QTY. DESCRIPTION
8 #8-18x1/2” Self Tapping Screws
1 Installation Instruction
Depending on unit purchased, kit
also includes:
QTY. DESCRIPTION
2 Charcoal fi lters
Alternate Electrical
Knock-out
Tabs