Installation Guide

Wolf Appliance, Inc. 800.332.9513 P.O. Box 44848 Madison, WI 53744 www.wolfappliance.com
812533 - Rev. A - 6 /11/2008
Page 2
DUAL FUEL RISER INSTALLATION INSTRUCTIONS
Assembling Riser:
Lay front panel on work surface 1.
cosmetic side down. Remove
protective covering from back side
of riser front panel.
Attach side support legs inside of 2.
riser front panel. (See illustration 1
for proper orientation) (shown as
they should appear when laying
on back of front panel)
Remove backing from the double 3.
sided tape on the center support
bracket fl anges. (See illustration
2)
Align center support bracket with 4.
center mounting hole on rear of
front panel. Verify that center
support bracket aligns vertically
prior to adhering VHB tape to rear
of front panel.
NOTE: Proper alignment is important
prior to securing tape to back side of
front panel.
Slide back panel inside of front 5.
panel mounting fl anges. (See
illustration 3) Align back panel
center notch with front panel and
center support bracket mounting
hole.
Continue installing fi nishing 6.
screws along center support
bracket and front panel mounting
fl anges.
CENTER SUPPORT
BRACKET
FLANGES
Illustration 2
Attaching Riser to Range:
Verify that all packaging material 1.
has been removed from riser
assembly and all packaging
residues have been cleaned from
stainless steel surface.
Remove the Island Trim that is 2.
factory installed on the range by
extracting the screw from each
side back and lifting up.
Remove screws that fasten the 3.
side panel to the back side of the
range.
Slide riser side support legs 4.
inside of range outer side panels
until bottom of riser assembly is
fl ush with the side panel. See
illustration 4. Verify that center
support bracket and side support
legs align with mounting holes.
Align center support bracket with 5.
range back panel mounting holes
and install screws (wait to tighten
them until after step 6).
Attach riser support legs to range 6.
side panel through unused holes
at back of range. (See illustration
4) Side panels screws can now be
reinstalled and tighten all screws
from steps 5 & 6.
Illustration 3
CENTER SUPPORT
BRACKET
BACK PANEL
SIDE SUPPORT LEGS
RISER ASSEMBLY
OUTER SIDE PANEL
RISER MOUNTING HOLES
Illustration 4
Shelf Install 20” Riser Only:
Once riser assembly is installed 1.
onto range, attach 4 (2 on each
side) shoulder screws in front
panel assembly.
Remove protective packaging 2.
material from shelf. Align keyhole
slots on back side of shelf
assembly with two shoulder
screws on the right side of front
panel and two shoulder screws on
left side of front panel assembly.
Slide shelf assembly into place 3.
and tighten shoulder screws if
necessary. (See illustration 5)
SHOULDER
SCREWS
SHELF ASSEMBLY
KEYHOLE
SLOTS
Illustration 5