User manual

RM-3358W User Manual P/N 821575 Rev-C

Please refer to Figure-2a on the following page to familiarize yourself with the front panel features of the RM-3358W unit. The

following sections describe these functions and are referenced, by number, to Figure-2a.

Section 2: Operation

Front Panel Features

Power Button (1-3)

These button switches (1-3) are used to cycle each individual LCD display ON/OFF.

A/B Source Select Switch (1-3)

In a standard configuration, this switch selects between the primary CVBS (VIDEO A) and secondary CVBS (VIDEO B)

video source inputs for the associated I/O Section.

If an optional SDI Input Module (RMSDI-1 or RMSDI-2) is installed in an I/O Section, the associated switch selects

between the primary CVBS Input source (VIDEO A) and the installed SDI Input video source (VIDEO B).

LCD Video On-Screen Display Controls (1-3)

Each LCD video display can be adjusted separately using the on-screen display controls. See page 10 for a description

how to adjust these parameters. The following parameters may be adjusted:

• Brightness - adjust for desired screen brightness.

• Contrast - adjust for desired image scene, dark-to-bright contrast.

• Color (Saturation) - adjust for desired amount of image color saturation.

• Tint (Hue) - adjust for desired image color hue (NTSC only).

• Dimmer Level - 1 to 8.

• Power Savings - ON/OFF (turns monitor off if no video signal after 6 seconds, returns power at signal).

• Frequency Subcarrier - select 3.58 MHz or 4.43 MHz for frquency subcarrier.

• Horizontal Normal - reverses image horizontally.

• Vertical Normal - reverses image vertically.

• Mode - NORMAL (original aspect ratio), ZOOM1 (arbitrary zoom in), or FIT (stretches image to fit screen).

LCD Video Display (1-3)

View input video sources here. Select one of two source inputs for each display by setting the A/B Source Select Switch

(Item 2) to the desired input (VIDEO A or VIDEO B). A number of screen image parameters are adjustable using the on-

screen display controls (see Item 3).

Note that when no source signal is being input to a powered display, a "NO SIGNAL" message will show in the display

screen until a source signal is applied.

Tally Indication LED (1-3)

This tri-color LED can glow RED, GREEN, or YELLOW to indicate tally status associated with the signal displayed.

Refer to pages 16 and 17 for tally connection details.

An optional audio indication module (AIM-1) may be installed into the Tally Control Connector on the rear panel (Item

E, page 12), which allows these LEDs to act as audio indicator lights. Please contact PANORAMAdtv for more information

about this optional feature.