User guide

821704: HDCC-200A (608/708) User Guide

RM-3270W HD Series User Guide

Using the OSD Menu

• Input Signal: The input signal is automatically detected as vertical

active line count, (i)nterlaced or (p)rogressive, and frame rate in Hz.

• Audio Levels: Levels for the audio channels are displayed on up to

eight meters as left/right pairs: maximum of four meters on the left

side and four on the right.

• IMD: The OSD MENU provides settings to customize the IMD (In

Monitor Display) text area to show a line of characters, numbers,

and some symbols.

• Time Code: The de-embedded time code from the HD/SD-SDI

source displays in the bottom right corner.

Using the OSD Menu

A description of how to use the OSD MENU follows. Also refer to Table

1–3 on page 13 for typical values and domain ranges.

1. Press the Menu button to display the menu.

2. Use the Up and Down buttons to navigate through the submenus.

3. Press the Enter button to enter the parameter selections in the

chosen submenu.

4. Use the Up or Down buttons to cycle through the submenu

selections.

5. When the desired option is highlighted, press the

Enter button to

select it.

6. Use the Up or Down buttons to adjust the parameter value up or

down, make a selection, or turn a function on or off.

7. Press the

Menu button to back out of a parameter or submenu.

Press the

Menu button again to remove the menu from the screen.

Note:

If you do not press another button for approximately 30

seconds, the menu will disappear from the screen.